Electronics Forum | Thu Nov 19 20:05:14 EST 2009 | davef
Density. There is a difference between lead (.410 lbs. per cubic inch) and tin (.254 lbs. per cubic inch). The same volume of tin-based solder, therefore, weighs approximately 1/4 less than a lead-based material. This adds up to more joints per pound
Electronics Forum | Tue Feb 08 04:27:55 EST 2011 | thomas111
hi, I am a Hardware designer . One of my products is undergoing a Reliability test in which a resistor shows a high value on board from its specified value .However it retains the original value when its cooled under room temperature. The resistor
Electronics Forum | Fri Aug 08 07:27:43 EDT 2008 | lonta96
Hi, I'm from a semiconductor package assembly, and currently looking for an offline solder paste inspector capable of true volume measurement. Any recommendation for a machine that can measure paste volume on a leadframe (metal substrate)? I found
Electronics Forum | Thu Apr 06 02:23:50 EDT 2000 | Marcus
What about your printer and your stencil ? Do you have a problem with misalignment between pcb and stencil ? How often do you clean your stencil during production ? Maybe you have smearing under the stencil because there is a snapoff between stencil
Electronics Forum | Fri Mar 09 08:07:28 EST 2001 | CAL
Fred- This is something we do often. We are located in Philadelphia right next to the Philadelphia Airport. We can also have an instructor on site to do training right at your facility with your product. We help many that are new to SMT to get up and
Electronics Forum | Wed Jul 09 18:02:48 EDT 2003 | slthomas
Just when you think you're getting somewhere... QA sent me a vendor response to our corrective action request. They stated that their normal process for this product includes an ultrasonic cleaning cycle of 20 MINUTES minimum. It might be 30, we'r
Electronics Forum | Fri Dec 17 14:13:18 EST 2004 | Claude_Couture
I have done this several times in order to save my butt: adding liquid flux in a jar of not so fresh paste, stirring it slow for 2-3 minutes, to make it usable. Of course, use no-clean flux for no clean paste, etc. During one production slow-down,
Electronics Forum | Thu Nov 03 08:34:25 EST 2005 | Slaine
Hi We currently use a small amount of Alloy : 43Sn 43Pb 14Bi Flux: RMA-51AC, Metal : 88.5%. We use it for reworking a product and only consume about 100g per year, we are in the middle or ordering in some more paste but the MOQ is 500g. Is it possibl
Electronics Forum | Fri Feb 17 14:00:26 EST 2006 | DannyJ
Baer, Sara, et al., Thank you all for your responses. I apologize, we have a new line installed and have been quite busy the last month... I'm downloading the video as I type this from pkay. Samir, please, if you get the sample and give it a tri
Electronics Forum | Tue May 16 15:30:07 EDT 2006 | George
Hi John, Are you talking about cleaning the pallets after running to store them? or during production? well in any case...I recently started to use this cleaning solution "Cybersolv" from Kyzen. It is water soluble and also can be used instead of IP
A leader in automated fluid dispensing, jetting, and conformal coating. Products include stand-alone dispensing workstations and fully automated, in-line conveyorized systems with advanced process controls.
2747 Loker Ave. West
Carlsbad, CA USA
Phone: 760-431-1919