Electronics Forum | Mon Jan 06 09:49:36 EST 2020 | andrewpayonk
Hello, I recently purchased a Hotflow 3 oven, using a step up transformer I received with unit, 220v to 480v. Unit turns on but does not heat up. Getting an F02 error saying no convection. I am getting 480v to oven, I also switched the phase still
Electronics Forum | Wed Mar 22 03:00:09 EST 2006 | meritajs
Hi All, We have problem with Zevatech FS-730 This machine shows error E202062: "System error: T axis of head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low speed it works s
Electronics Forum | Fri Nov 11 04:06:46 EST 2005 | arnold
we are manufacturer of molded type transformer. we have a trim and form process and its damage the pins of our units. the TIN insulation was being damage so we decide to immediately solder (wave soldering) the units to avoid oxidation. my question is
Electronics Forum | Fri Nov 11 04:13:23 EST 2005 | arnold
we are manufacturer of molded type transformer and we soldered are units using wave soldering machine and then we washed the units to remove flux residue. what materials or any process for us to eliminate the process of washing after wave soldering.
Electronics Forum | Mon Nov 07 15:05:16 EST 2011 | tpappano
Hi Jeff, This machine (my unit #2) has a couple programs that execute just fine, but when I added additional mounts to one of them I got the "120"error. When I added another new program, the "118" error showed up, and of course, everything in all t
Electronics Forum | Mon May 16 10:43:22 EDT 2005 | wizy
I would like to ask, if somebody know, what I have to do with "L3 TIME UP" error message in MPA-V, or where can I switch off the coplanarity unit?
Electronics Forum | Thu Sep 15 15:17:21 EDT 2005 | GAK
What kind of error code do you get? Check your sensers my be bad.
Electronics Forum | Tue Aug 19 14:24:22 EDT 2008 | shanenaturalpoint
My first problem is that when the unit homes, the print carriage seems to be traveling too far back. After the carriage reaches its mechanical limit, it continues to try and move back, eventually throwing up a print carriage error. Any ideas?
Electronics Forum | Wed Feb 03 03:49:56 EST 2016 | webjelen
I have QP242E with two modules MFU-58. I need put tray unit STU1 to Modul2 but optimalization end with error. Module1 is alright. Setting Modul1 and Modul2 is same. Any advice ? Thanks
Electronics Forum | Mon Dec 26 19:18:49 EST 2005 | arnold
I would to ask on what do you call on the color green contamination found on the soldered units. Whe i soldered some units after few days there was a color green on the wires. what do you call on this contamination?
