Electronics Forum | Wed Jan 28 08:56:40 EST 2009 | blnorman
Don't know the specifics from the IPC spec. However our standard internal spec dictates - highest thermal mass, lowest thermal, most critical component, and center of PCB on the laminate surface. Our profilers have 6 inputs, so the other 2 are dete
Electronics Forum | Sat Jul 25 05:19:48 EDT 2009 | stephan
Hi Davef, I checked this spec but the value is not mentionned . Have you , any of you other idea about spec mentionning this allowable PCB stretch (i.e. IEC ... ) ? Thanks for your time of reading this Stephan
Electronics Forum | Tue Jan 12 12:05:50 EST 2010 | lynn_norman
I assume the spec follows most spec protocols which means "should" is a recommendation, not a requirement (which would be stated as "shall"). Still doesn't sound like a good idea though.
Electronics Forum | Wed May 05 08:50:37 EDT 2010 | flipit
You will want to look at the Mil Specs. I believe they are all available online in pdf format at no cost. I am not certain what the latest spec is but Mil-Std-2000 absolutely has a section on this.
Electronics Forum | Tue Jan 25 21:35:26 EST 2011 | rway
It seems 1/16" has been speced (component to pcb edge). This is our spec and we conform to IPC, but I am not completely sure if this is what IPC std states. Does anyone else know if this is in deed the true spec?
Electronics Forum | Mon Dec 03 04:05:40 EST 2012 | markmaas
What type of Assembleon equipment do you have. For A-series the following air spec applies: - Max. oil content:
Electronics Forum | Thu Oct 09 05:43:47 EDT 2014 | cspasol
Anyone know the Hexi Reflow Oven (SF-820-LF) Zone Motor Specs?
Electronics Forum | Sat Nov 19 01:21:00 EST 2016 | smonk
Hi im looking for information on the samsung cp30v to confirm its specs. does anyone have a soft copy of the manual or a list of what components it can place etc? THanks a lot s
Electronics Forum | Thu Apr 20 20:04:39 EDT 2023 | jamesatqkits
5 ppm from cylinders, thank you for taking the time to respond. Originally I ran no spec nitrogen, and got good results, when I started having issues I changed to 4.8 spec
Electronics Forum | Mon Apr 09 16:46:54 EDT 2007 | stepheniii
Basically its spec. gives surety regarding its > chemical and physical properties. if he doesnt > follow the spec then may be he may find good > physical soldering appearance but chemically it > may goes down through Electrical or Environmental