Electronics Forum | Sun Apr 13 02:36:06 EDT 2014 | alexeis
Hi, We have system called Setup Center for Samsung that can give a solution to your needs. It loads samsung files, including before and after optimization, and gives you feeder list splitted by machine and side (Front/Rear). Also, you can go over on
Electronics Forum | Wed Jan 21 04:07:09 EST 2015 | xboxhaxorz
Most serious rework stations are from ersa, pdr etc; We actually wanted a fully automated system with split vision and in USA that would probably cost around $50k. We decided on a ZX360 which is about 300 lbs and it worked quite well without issue fo
Electronics Forum | Sun Feb 21 09:02:38 EST 2016 | alexeis
Hi, We have developed solution, called QPlan, that is reading CAD (different formats), merging it with BOM (including check of BOM and compare exceptions), comparing with your history library of Assembleon/Philips, simulating SMT process with automa
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Mon Feb 12 08:37:04 EST 2018 | dontfeedphils
The piece that splits the vision probably has smudges or scratches on it. You're able to teach a set of pads. Before teaching the fid, hit the "Draw Correlation Box" button (I think that's what it's called, it's been a couple years). Then draw a b
Electronics Forum | Wed Aug 01 16:50:40 EDT 2018 | stephendo
A few times I have had success limiting movement in the oven by splitting up the paste apertures. In this case it might work if you had three bricks perpendicular to the leads.(maybe more) The trick would be making the gap between them big enough to
Electronics Forum | Thu Dec 20 09:50:44 EST 2018 | stephendo
Once a long time ago I had a board where the cap beside a tantalum shifted in the oven. I phoned our HQ plant and was told that they had the same issue and that it was the tantalum capacitor outgassing. We just applied a dot of glue to the cap. Try b
Electronics Forum | Tue Jan 07 02:04:45 EST 2020 | robl
Hi Mikey, Your signal pins (2 & 3) for USB1, 2, & 3 are all connected together so there is no way of splitting the incoming signals from the 3 ports. Normally there would be an IC (a USB hub controller) switching between the signals so that the PC
Electronics Forum | Tue Aug 04 14:28:39 EDT 2020 | ttheis
Yes, I am certain it is 240 corner grounded delta. It confuses many electricians and it took me some time to understand. It is fed from a 480:240 delta 200A transformer. As I mentioned, they have a lot of Bridgeport 3ph machines and cnc machines conn
Electronics Forum | Wed Oct 25 06:14:14 EDT 2000 | Adam
Guys A question regarding design rules of a WSC.We are currently running a high volume product, and as usual the design layout is as such where half the through hole connectors are perpendicular to the wave, and surprise,surpise the other half are'n