Electronics Forum | Mon Apr 26 17:20:10 EDT 1999 | Chrys Shea
Hey MoonMan, Did I catch in one of your fabulous threads that you're using Tetra stencils? I'm anxious to find out how you're liking them. We we're all set up to go to Tetras, then mgt decided to close down our factory - Dooop! "Foiled" again! (te
Electronics Forum | Wed Feb 09 12:31:54 EST 2005 | russ
We are not doing this right at the moment but I have done it with great success. Of cource it depends on your pad layout we have a 20 mil gap in between pads, we printed at 10 mil wide with a 5mil stencil. I will try to find the glue we used, I kno
Electronics Forum | Thu Oct 01 13:33:01 EDT 2015 | marlyn
Hey there fellow people with SMT > issues... What's the proper procedure for > soldering through-hole headers on the back-side > of the PCB (pins poking out on same side as SMT > parts)? ( Yes - I did the SMT side first and am > now faced with L
Electronics Forum | Sat Feb 06 16:42:18 EST 2021 | sg7914
Respected all; I am currently a student at RIT and working towards my master's in Manufacturing and Mechanical System Integration with a specialization in Electronics Manufacturing. I came across an interesting topic regarding the tooling and fixt
Electronics Forum | Mon Apr 26 17:31:14 EDT 1999 | Earl Moon
| Hey MoonMan, | | Did I catch in one of your fabulous threads that you're using Tetra stencils? I'm anxious to find out how you're liking them. | | We we're all set up to go to Tetras, then mgt decided to close down our factory - Dooop! "Foiled"
Electronics Forum | Tue Nov 28 21:16:17 EST 2006 | davef
J Rose at EMPF says: The introduction of no-clean solder fluxes in electronics manufacturing has given rise to greater levels of solder balling simply because the opportunity to remove them in the wash process does not exist. They are typically cause
Electronics Forum | Wed Mar 02 18:46:02 EST 2005 | Austinj
The tendancy always has been "when in doubt, touch it up"... this is not the way to "verify the process" and is not the best strategy for multiple reasons (unessecary rework, additional labor costs, as well as making the solder joint more brittle, [i
Electronics Forum | Tue Apr 10 02:57:53 EDT 2018 | rob
Yes I would, most of our old Yamaha machines (before 2005) will do 30-35 microns @ 3 sigma with the fine camera option. Our Jukis with His res camera's will hit it too. You should be OK with most things after 1997 with the right camera choice (whic
Electronics Forum | Fri May 23 07:07:39 EDT 2003 | qp1
Please your comments for placing 0402 on CP4? Which are the difficulties to expect and how to threat them? How to adapt the feeders for the smaller interdistance of the tape?? Thanks
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
