Electronics Forum | Fri Oct 12 10:21:03 EDT 2012 | chox
I am looking for someone to contract to come to our facility to provide training on Philips Topaz and/or Quad QSV-1. We are looking for programming, operation and maintenance training. I would prefer someone local.
Electronics Forum | Tue Sep 24 18:10:39 EDT 2013 | nophsem
Hi! During the operation there were random errors, mainly motor error #4, but I could continue with the production, and finally I restarted the machine and immediately appears: SRX AUTOBAUD Engine error # 5 I would appreciate your help. Thank you.
Electronics Forum | Thu Sep 13 10:49:24 EDT 2007 | slthomas
If someone knows specifically what the sequence of events is in a Topaz placement step I'd appreciate it if you could share that with me. We've developed an intermittent problem with ours where it places the part and immediately stops with E0873. T
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Wed Feb 13 14:35:57 EST 2019 | aldrich17
we do see some inconsistencies with fiducials. We use X, Y references in the machine but still find them with the camera to populate pcbs. But just can't always center the cross-hairs in the fiducial. Most of the time we have to offset the cross-hair
Electronics Forum | Thu Aug 02 14:27:28 EDT 2007 | slthomas
We're having problems figuring out how to optimize our stick feeders. We want to keep them all on the back side but the only way we've been able to get the data generator to finish optimizing without errors is to make all feeders movable, and it send
Electronics Forum | Mon Apr 27 11:29:06 EDT 2015 | chris_jayconsystems_com
When I do the adjust to make sure the vision and tolerance is working it works perfectly. But if the machine runs a board I am riddled with this. I have checked the vacuum levels on all the heads and they are within where they are supposed to be for
Electronics Forum | Wed Feb 13 15:12:09 EST 2019 | slthomas
The reason I asked about using X-Y data (originated from the pcb files) is that if you bombsite the locations with the camera and program or adjust them individually, you run the risk of having to do it over and over when fiducials change, your fixtu
Electronics Forum | Thu Feb 29 02:24:55 EST 2024 | redspare1
Strange error, I have looked at the schematic and checked all of the e-stop switches and they're good. The machine isn't connected to anything, but air and power. Has anyone else seen anything like this? 1. When pressing the active button it beeps
Electronics Forum | Fri Jun 04 20:08:13 EDT 2004 | Ken
Rick P. is the Assembleon local Field Service Engineer. He is very good. He is stationed in the Portland Metro area. Oregon and Washington have a very dense population of Philips (assembleon) machines. Extensive installation base. I recently in
