Electronics Forum | Mon Oct 29 14:05:39 EDT 2018 | reckless
I agree. Not sure what type of support there is on old machines. I was confused as the GEM machines were manufactured by Yamaha. Is there any issue with it being a DOS based machine? We are only running 1-2 main boards so no changeovers.
Electronics Forum | Tue Dec 01 15:43:04 EST 1998 | Chuck Footit
| We are considering a used Yamaha YM84V II to add to our existing compliment of stand-alone machines. The brochure states that it can place 0603 devices as standard. Is this true? Do you know of any quirks with these machines? Any comments would be
Electronics Forum | Mon Oct 24 11:04:58 EDT 2022 | richardcargill
The yamaha feeders need leader tape to function - so if you're using cut reel components you'll lose 3 or 4 just on set up alone. Run-time attrition is harder to help with as machine setup and calibration, condition of nozzles/feeders, ability of ope
Electronics Forum | Tue Apr 10 02:57:53 EDT 2018 | rob
Yes I would, most of our old Yamaha machines (before 2005) will do 30-35 microns @ 3 sigma with the fine camera option. Our Jukis with His res camera's will hit it too. You should be OK with most things after 1997 with the right camera choice (whic
Electronics Forum | Wed May 29 12:19:03 EDT 2013 | kevslatvin
Oh yeah I saw Trans Tec is offering support for the Yamaha made Assembleon machines. I believe this was the GEM series and the MG series that replaced them so they may have some as well.
Electronics Forum | Mon Jan 31 17:57:28 EST 2022 | compit
In my machines (Yamaha / Assembleon / Philips) there is an option to FIRST rotate the element and then check it with a camera (I do not use it, because it requires an additional better camera) - maybe you will find something like that at home?
Electronics Forum | Fri Oct 27 03:02:54 EDT 2017 | praveenmuthusamy
Dear All, what might be the reasons for servo alarm on W axis in YXI(X RAY INSPECTION MACHINE)?? MAKER: YAMAHA TYPE: KLC-0000 NOTE:MACHINE CANNOT BE RESET UNLESS POWER SHUTDOWN. MACHINE RETURNS TO NORMAL STATE ONCE POWER SHUTDOWN AND RESATARTED! R
Electronics Forum | Sun Oct 04 20:55:44 EDT 2009 | phomann
Hi, I have a test pcb that came with my Yamaha YM84S machine. The board contains land patterns, fiducials, etc. The pyrpose of the board is to test the placement and vision systems in the machine. Does anyone provide the technical drawing of the bo
Electronics Forum | Tue Sep 22 13:51:23 EDT 2020 | makersan
Hi If anyone uses a label feeder in yamaha ys12f model p & p machine, Can it tell you how to connect the machine with the label feeder? The label feeder we will use is in the link below. https://label-feeder.com/wp-content/uploads/2015/07/Product-
Electronics Forum | Sat Nov 11 19:07:34 EST 2000 | George
Hi Jax, CAD Software is Protel and the machine is Yamaha YM84 Hyper Series. thanks