Electronics Forum | Tue Aug 18 22:22:43 EDT 2009 | comatose
Assuming you want to run 8 hours a day and 5 days a week, you need a sustained throughput of 2.5k components per hour. With fine pitch, futzing around, setup, etc you should really look for machines rated in the 4k to 5k per hour range. That's not sc
Electronics Forum | Thu Apr 29 10:24:15 EDT 2021 | oxygensmd
I have the same issue but with one customer only. All the other have smaller or more difficult QFPs with really low bridging issues - close to no-one. I think the PCB and PCB design also an issue - other customers are using 32/64/100/144 QFPs and we
Electronics Forum | Fri Jun 25 01:11:31 EDT 1999 | Vinesh Gandhi
| | | Recently, there has been an upsurge in the Pin Hole/Blow Hole problem in our wave soldering process. We are baking the PCBs for 2 Hrs. at 125 degree C. The Wave Soldering profile seems to be O.K. Still the problem is persistent. Can somebody
Electronics Forum | Wed Jan 06 04:51:16 EST 1999 | Earl Moon
| | A question for you all! | | | | Back in the good old days, we didn't always know how clean was clean. Much has changed. Much hasn't. | | | | My question concerns cleaning under, through, and around tight spaces. Way back when, we could not clea
Electronics Forum | Tue Oct 12 17:40:01 EDT 1999 | Brian W.
| | | A question for you all! | | | | | | Back in the good old days, we didn't always know how clean was clean. Much has changed. Much hasn't. | | | | | | My question concerns cleaning under, through, and around tight spaces. Way back when, we coul
Electronics Forum | Mon Feb 16 12:33:58 EST 2015 | ianatvadatech
Hey Syed, I've been running the MV-9 for just over a year. We shopped around very extensively (two APEX shows) before switching from yestech to mirtec and we bought two of the best systems they had to cover the four lines we run. Two systems are fa
Electronics Forum | Wed Jul 30 00:47:10 EDT 2014 | matusov
Hello gurus, I am a hardware designer with a small company. We are about to send a new PCB for fabrication. This board uses dozens of tiny QFN, DFN, and similar packages. As a final check I have been going through the datasheets of all these parts t
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
Electronics Forum | Thu Feb 12 22:21:08 EST 2015 | shahrat
So what problems you are facing with Mirtec? Can u check coplanarity, less solder, polarity, dry solder,Pads not properly got the heat for 1005 package. Can u also check 0105 components that is surrounded by some tall components? what about false cal