Electronics Forum | Fri Feb 15 12:51:30 EST 2013 | emeto
Hi MikeS, I didn't post all the information, because I didn't want to mislead you. I wanted to see your way. We tried 3mil and 4 mil stencil using type 4 paste. It was hard to get the right aspect ratio and that;s why we did it on Nickel stencil - a
Electronics Forum | Fri Feb 15 14:38:59 EST 2013 | bmario
Hi, We are having a problem with the interpretation of the surface evaluation criteria of J-STD-003 section 4.2.2.4.2. "A minimum of 95% of each of the surfaces (i.e. each pad) being tested shall exhibit good wetting. The balance of the surface may
Electronics Forum | Fri Jun 14 05:49:32 EDT 2013 | rollon65
Hi all. I used a 5/16" white paper sticker to mark a reject PCB in a panel of 10. One of my my Quad 4Cs sees it O.K. and marks the PCBs reject. The other machine either shows them all reject or shows the marked one as good and the other 9 as rejec
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
Electronics Forum | Fri Aug 30 11:31:29 EDT 2013 | nophsem
We have two QUAD 4C working in tandem. 3 months ago the EPCU battery (QUAD # 2) died, then we change it. Then downloaded the MODs from the controller to the assembler(does simultaneously on both machines). All this time we continue to work normally.
Electronics Forum | Thu Sep 05 21:31:36 EDT 2013 | nophsem
Hi: Our machine (QUAD 4C) has a CyberOptics laser 6604033; when initialize at HOME, z-rod descends and doesn't retracts, which makes me think that the laser is misaligned, here's a link to the video recording: http://www.youtube.com/watch?v=W9ma7Zsf
Electronics Forum | Mon Sep 30 15:26:48 EDT 2013 | leemeyer
I have been using Quad 4C's for 15 years and have never come across this error. Everything initializes OK but when I start a program through Central Controller I get an "OUT OF MEMORY" error. I have flushed the Mod codes and re-entered them and have
Electronics Forum | Tue Oct 01 07:10:02 EDT 2013 | bobpan
It could be PC Memory or maybe a full hard drive. I would check the following first. 1. Reset board count (there is a bug that causes problems if the count gets too high.) 2. Make sure ROA=OFF if the line is in your configuration file editor. 3. Ma
Electronics Forum | Mon May 12 04:26:00 EDT 2014 | gazelle
Hello - I am looking for a source to supply low thermal EMF solder - can anyone provide pointers ? In the past a cadmium - lead alloy was used for this, but these are banned (RoHs) ... - the aim is to minimize thermo-couples on a very sensitive 4 lay
Electronics Forum | Fri Jun 27 11:56:37 EDT 2014 | sumote
Colleagues, I have a JT-620L Wavesolder machine (Made by JYI DIANN MACHINE) that experienced a power fluctuation and had the factory programming wiped. If someone would be so kind to read the settings on the (4) VS-606V7 controllers I would be very