Electronics Forum: setup (Page 85 of 148)

Fuji CP6-4000

Electronics Forum | Mon Dec 17 09:15:57 EST 2007 | kpm135

I have personally worked with MYData, Quad, and Panasonic in the past. We are a High Mix, Low Volume CM. The plan that is in the works is to use the CP6 to place all chip components and then use our MYData TP9 or MY12 to place the rest of the compone

Prototype SMT & Ltd Prod Line Choices & Advice

Electronics Forum | Wed Mar 12 13:16:42 EDT 2008 | ipdisplays

Hi All, I know some of this has been covered - but nothing recent that I could find - so please bear with me... Seems like the used/refurb market is kind of fluid so would like some current thoughts.... I'm looking to setup an inexpensive prototype

High mix low volume

Electronics Forum | Wed Apr 16 14:40:17 EDT 2008 | jdengler

Peter, We have 2 Fuji lines. We run from 5 to 5000 piece lots. When we are running near capacity and have a lot of change-overs scheduled we have special operators that will load parts onto feeders and organize the feeders like they will be on the

OT: Wavesolder Process Engineer Needed

Electronics Forum | Tue Jul 15 10:05:23 EDT 2008 | patrickbruneel

Ck, Just to make myself clear I am not at all questioning your observations. What am trying to make clear is that when your wave contact area changes when the PC board or glass plate traveling speed is changed, something is wrong!!! Also an 180Deg

YESTECH OR MVP? LOOKING FOR AOI.

Electronics Forum | Fri Sep 05 19:56:56 EDT 2008 | hegemon

We did extensive side by side (by side) testing of three AOI machines Omron, YesTech and Mirtec. In the end, even with weighted scores, the difference in the top two machine was still only four/tenths of a point. Third place was a distant 14 points

Juki pick and place ?

Electronics Forum | Tue Sep 02 18:49:05 EDT 2008 | jlawson

Juki machines generally are great machines for reliablity and maintaining overall accuracy as they have full linear (mag-scales) encoders on XY axis and self calibration features. Laser centering has its pros and cons - mostly pros, but can have iss

Quick Turn Around for an EMS Provider - Brainstorming

Electronics Forum | Mon Jan 12 12:43:34 EST 2009 | smt_guy

With the High Volume Manufacturing in United States became lesser and the current crisis that the country is dwelling in, Low to Medium Volume - High Mix Manufacturing is very common and small EMS Providers are scrambling to get a Pie of the Job. I

First piece PCBA validation

Electronics Forum | Wed Dec 15 16:17:30 EST 2010 | rgduval

Sounds like there may be a people problem somewhere in your process. We have a couple of checks set up to aid with capturing first article issues. First, of course, the kit is checked against the BOM to ensure that all of the parts match. Then, we

Adhesive Dispensing using PDP head

Electronics Forum | Wed Jun 15 22:27:40 EDT 2011 | pkamath2

Hello, My company recently installed a Positive Displacement Pump on a GSM Pick @ Place machine for dispensing chipbonder (loctite 3621) dots before mounting chip components. The head uses Universal stand nozzles (single port-small dot, dual port 0

ICT testing to improve yields

Electronics Forum | Mon Aug 27 08:52:57 EDT 2012 | rgduval

Reese, We would agree about the value of an ICT system, in a general manufacturing environment. However, a couple of notes apply: 1. ICT isn't a catch-all, either, and should be used to verify the process, not validate it. Quality should be buil


setup searches for Companies, Equipment, Machines, Suppliers & Information