Electronics Forum | Fri Jan 13 02:54:25 EST 2017 | roblackey
When the YV100 starts up if you press a key > during its startup you can get it to ascreen > where it asks for passwords.. > > How would you > get the passwords from this Hi, if you haven't changed them then I think it's "specialist" on VIOS.
Electronics Forum | Fri Feb 10 03:14:53 EST 2017 | soldertraining
Which is the best way to clean the PCB after soldering? Is it good enough with IPA (isopropyl) or with the Flux Remover spray? However, we use a lead free solder wire (3,5% flux inside the core) and after the soldering its a visible wet and surface g
Electronics Forum | Mon Apr 24 11:44:53 EDT 2017 | emeto
It is good to have: conveyor after SPI(if you don't have SPI should be after the printer), conveyor before the oven(inspection station is better), conveyor after the oven - before your destacker if you have one. The rest of it, depends on how long li
Electronics Forum | Tue Oct 29 21:27:21 EDT 2019 | aqueous
It depends on the flux type. If it's water soluble, it should be cleaned soon after reflow because OA flux remains active after reflow. If it's rosin or no-clean (low-residue), then the only concern is the longer wait time, the more difficult it will
Electronics Forum | Mon Oct 12 01:20:42 EDT 2020 | azdback
LandrySMT, after monitoring the errors and considering what we replaced, I also decided to replace the Z hydra motor and encoder. That fixed our problem. I looked at your message and I agreed that the next step was to replace this part. We ran hi
Electronics Forum | Wed Apr 20 18:06:37 EDT 2022 | kumarb
For future readers - just needed a little bit of lube. Many thanks to Michal & the staff @ Trans-Tec (USA) for their excellent support, as always. Please see attached. For our (dated) machine, the black dial would turn only after hitting the gym
Electronics Forum | Mon Oct 02 21:16:05 EDT 2023 | seonr
Thanks for the suggestion. Unfortunately, there are 2 issues with adding them after: - The first is that doesn't scale to 1000's of board - The second is that half (or more) of the boards are double sided, complete PCB coverage on both sides and nee
Electronics Forum | Fri Jun 02 16:30:42 EDT 2000 | Michael Parker
I found a reference to Cost of Conversion earlier this year. Basically, the average cost to convert a single component from raw materials to assembled goods is $.08, just after pick and place. After placement and before reflow, repair (solder paste r
Electronics Forum | Wed Mar 14 18:29:04 EST 2001 | mparker
The basic rule of thumb (info current as of 9/2000, from Ceeris and others) is the 10X multiplier for each major process step. Catching a defect and correcting in SMT will cost $0.10 each. (think about $.04 placement cost, stop line time, operator h
Electronics Forum | Wed Oct 27 16:44:58 EDT 1999 | John Thorup
at least most of a posting is dropped after a sentence or two?