Electronics Forum | Sat Aug 27 12:45:44 EDT 2005 | Mark
Thanks for the replies. Interesting white paper. Didn't quite answer my concerns but still a good read. I was actually surprised that to test temperature uniformity across the zone, they attached T/C's to the substrate rather than measure the ai
Electronics Forum | Sun Sep 28 17:14:53 EDT 2008 | ronsou
small pads like 0402 tend to get hot quite > easily. looks like excessive heat is your problem > here. pads are wetted, component leads are not. > this means solder paste flux on top layer was > exhausted before entering in reflow. your profile
Electronics Forum | Fri Jan 05 09:23:10 EST 2001 | Brian Toleno
While there may not be any specific requirement to cleaning prior to coating, cleaning an assembly prior to coating will only serve to increase the reliability and integrity of the coating. Some residues from low-solids fluxes can interact with conf
Electronics Forum | Fri Jul 30 17:16:59 EDT 1999 | Dave F
| Hello Netters, | | I have a customer who wants us to aquaeos wash a PCB after all operations have been performed. The PWB is two layer FR4 with a Transformer, a Multichip Module with Conformal Coating, (6) 11" insulated wires that are tinned on e
Electronics Forum | Fri Jul 30 17:24:24 EDT 1999 | Dave F
| | Hello Netters, | | | | I have a customer who wants us to aquaeos wash a PCB after all operations have been performed. The PWB is two layer FR4 with a Transformer, a Multichip Module with Conformal Coating, (6) 11" insulated wires that are tinne
Electronics Forum | Thu Jul 15 11:57:15 EDT 1999 | nards penalosa
We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec dwell
Electronics Forum | Thu Jul 15 12:26:56 EDT 1999 | Earl Moon
| We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec dwe
Electronics Forum | Thu Jul 15 15:55:41 EDT 1999 | nards penalosa
| | We have been encountering diminishing ball shear readings these past few weeks, despite the fact that we did not change any ball shear tester parameter. Our reflow parameters are also within spec limits. ( 210-220 deg C max temp. and 40-60 sec d
Electronics Forum | Mon Oct 26 20:18:23 EST 1998 | Dave f
| I need some info on how to stop the bridges I'm having on | radial and axial parts that are in the same place on every board. I'm also having problems with sot-25 bridging. I'm using a Electrovert E-pak. I tried leveling the machine,solder pot, an
Electronics Forum | Tue Jun 23 12:39:58 EDT 1998 | Brian Conner
I am experiencing a wave-soldering problem with a leaded capacitor - too much solder above the board!! The capacitor lead is .020" dia. and the hole size is .038". This only occurs on the negative lead of the component. The capacitor is also axial