Electronics Forum | Thu May 31 18:37:22 EDT 2007 | alandra516
I dont know if this helps, but the FDC was made by ECD controls. You might contact them
Electronics Forum | Thu Oct 04 09:35:51 EDT 2007 | pbxtech
Thanks Jon! Good to know! I don't think my iron is ever set at 300*C, haha :), so mineral oil is probably not my best bet. I'll try getting some of that copper grease.
Electronics Forum | Mon Jul 07 13:10:54 EDT 2008 | dphilbrick
I have a working unit with software fully loaded. email me at sales@worldeb.com if you need one.
Electronics Forum | Tue Jul 15 12:11:22 EDT 2008 | gabriella
Hello, I would remove a link, if I was you. As I can hear from you their support is not good anyway(if it is in warranty, they should help you, wright?).
Electronics Forum | Tue Jul 15 13:42:36 EDT 2008 | dwelch123
Ed, sounds like your tech. is full of *hit. He must be fatter and lazier than me!! I'd call Essemtec and make sure that his statement is correct, and if it's true, Gabriella is right. Have a good one bud.
Electronics Forum | Thu Jul 24 00:35:43 EDT 2008 | chip_flip
I would remove enough links to get the tensioning assembly back where you have room for adjustment again. I would have to agree that if the machine is still under warranty you should have Essemtec correct the issue.
Electronics Forum | Fri Oct 03 15:18:27 EDT 2008 | davef
Good ol' general purpose, day-in, day-out ~$1k hot air rework stations are: * Pace ThermoFlo ST 300 Low Cost Hot Air Reflow System [ST 325 is digital] * Hakko FR-803B SMD Rework Station [FR-802 is digital]
Electronics Forum | Mon Nov 03 07:47:47 EST 2008 | jdengler
mickd, I prefer a rail of 7.62mm (0.300"). This alows for the tooling pins and fiducials without any trouble and minimizes the waste. A fiducial of 1mm round with a 1mm clear area around it. Jerry
Electronics Forum | Wed Dec 03 10:24:31 EST 2008 | vleasher
Our UIC Lightning Head is having pick issues with Vishay reels (0402,0603) when the reel are near the end. It occurs ~300-200 pieces before the end of the reel. Pick point was confirmed and is consistent. Has anyone experienced this issue nearing the
Electronics Forum | Wed Dec 17 08:43:14 EST 2008 | stiva
Have seen this problem on other types of oven and it was caused by failed solid state relays that energise the heaters.