Electronics Forum | Wed Nov 15 06:44:54 EST 2000 | andy
John , I had some experience of selective solder in a high throughput environment and though the quality of s/s was good , the throughput was not . So if throughput is an issue , forget it . I would go with the hand-solder option , although as has be
Electronics Forum | Fri Oct 20 13:57:35 EDT 2000 | Greg Amero
Most LCD manuf. specify not to wave or reflow. I believe this is because of the prolonged exposure to the preheat temp. However, about three years ago, we were running about 350/wk of a 40P DIP LCD through the wave with no fallout. It did stress t
Electronics Forum | Mon Jun 18 11:34:00 EDT 2001 | Gil Zweig
As you probably have discovered, the cost of x-ray inspection systems can run anywhere from $35,000 to $350,000 or more depending on if you want an In-line or off-line system. Assuming ,in your facility, you want an off line system, then the next con
Electronics Forum | Fri Jul 23 01:32:21 EDT 1999 | KYUNG SAM PARK
HI Earl Thank you for your answer. Let me know you about the hot you mentioned First of all, The rework machine is the BGA3500 (manufactured by 0.k international:U.S.A) ��DESOLDERING HEAT :OVER 200��(CENTIGRADE),30SEC(CHECKED BY
Electronics Forum | Thu May 06 18:36:06 EDT 2004 | gustavo
I can help you, if define what type of components you used: Thru hole(axial,radial, pin insertion etc..) axial: milimetrics or standar(span of .200" or .350" ) radial 2.5mm , 5mm or 7.5 mm SMT (chip shooter(1206,0805,0603 ,sot 23 etc or more small
Electronics Forum | Mon May 24 15:50:11 EDT 2004 | Rob
hi all What do you think about soldering pb-free in reflow oven (air) lenght 1,7m (5 zones top,bottom) with max zone temp. 300C? Do you think that this process will be stable? Our max PCb dimension 260x260 mm. When i compare different oven producer t
Electronics Forum | Thu Sep 02 10:43:02 EDT 2004 | Frank R.
Thanks Russ, Concerning PCB, I will consider positive and negative informations for all material exept OSP. I work with 350 persons in production and if the final result of the product is different depending of the person who andle it, I can't use t
Electronics Forum | Wed Sep 08 01:10:30 EDT 2004 | alan
We have an issue with our Seho Wave solder machine. The machine is an 8040C, early 90's model. The problem is that continues to heat the solder up, even once it has reached its specified temp. If we set it for 250 degrees, it will go to 250 then c
Electronics Forum | Wed Sep 15 17:31:40 EDT 2004 | GS
Once you verified for correct profile ( consider CTE mismatch) make sure before you remove PBA from fixture, the temperature is almost at room temperature. If by removing PBA from fixture,and the PBA gets a little bent (warped) just in the area where
Electronics Forum | Fri Jan 14 00:14:48 EST 2005 | fastek
Grant- Ask yourself this question: Can your company afford to spend $350K on the best line possible? Because that is what it will cost you to get in to a used CP-643 and GSM-2 line. Bite off on that and your world will become rosy again. Buy those t