Electronics Forum | Wed Aug 07 01:44:52 EDT 2019 | orbitcoms
I have several reels of components I purchased from Chinese source. During pick and place, the tapes keep breaking (they tear diagonally along the reel). I notice the tape is very tight if I try to pull through manually. I tried several over 12mm fe
Electronics Forum | Fri Feb 01 08:40:12 EST 2008 | jdengler
Hi AJ, Change ALL 12 of the 1.0mm to 0.7mm. The CP 4 can only set nozzle size for S M and L not some of the 12 but all 12. 0402 usually come in 8 x 2 mm tape so you need 8 x 2 feeders or you will waste 1 component for every component you use. T
Electronics Forum | Wed Sep 30 08:29:15 EDT 2015 | johanbergstrom
The difference between TMC Flex and TMD Flex is about the ability to feed component tape with deep pockets for larger components. The TMC have a rather low passage for embossed component tape. While TMC Flex is limited to a maximum tape depth of 7,5
Electronics Forum | Wed Apr 23 07:46:49 EDT 2003 | pbc1963
Bernard, The problem we have is when unloading the feeder several components may be lost due to the partial peel back of he cover tape. This area I am referencing just passed the point of the knife to the pick area. Also matching the correct feeder
Electronics Forum | Sun Feb 06 15:38:39 EST 2005 | Grant
Hi, I think we would get a jam up every hundred parts or so, and it's worse in cover tape that's glued down. The problem is the Agillis feeders push the cover tape to the side, which works ok on 8mm tapes, but on wider 12 and 16 mm tapes it's a nigh
Electronics Forum | Tue Mar 16 18:05:52 EST 1999 | Stefan Witte
| I am in need of feeder that that will feed a 76mm wide tape @ a 60mm pitch to be used on a Universal GSM. | It is not a standard tractor feed, so it would require quite a bit of ingenuity. | Does anyone out there know of someone who designs and bui
Electronics Forum | Wed Mar 17 09:39:04 EST 1999 | Mike Evarts
| I am in need of feeder that that will feed a 76mm wide tape @ a 60mm pitch to be used on a Universal GSM. | It is not a standard tractor feed, so it would require quite a bit of ingenuity. | Does anyone out there know of someone who designs and bui
Electronics Forum | Wed Apr 08 17:42:24 EDT 1998 | Wayne
| For nearly 30 months I have waited on Contact Systems | resolving indexing and clearanceproblems with their | 32mm and 44mm tape feeders. I think that the service | that they offer is pretty poor. | Am I alone? Does anyone else use their larger
Electronics Forum | Mon May 12 15:08:11 EDT 2003 | stefwitt
1. Not quite. The width of 16 mm came most likely from the reel width, which can be up to 15 mm wide for the 8 mm tape. The reel for the 12 mm tape is up to 18 mm wide and would occupy already two slots. If you design a machine from scratch, I would
Electronics Forum | Wed Feb 05 22:03:21 EST 2014 | alphatronique
Hi as said clip and and adjustment was not in cause if you look picture part was right at the good place so tape adjustment was good for all the 16 tape and have also replace all the 16 clip whit same result i have service any mydata feeder bef