Electronics Forum | Wed Jun 24 13:46:41 EDT 1998 | Chris Kelly
Brian, a couple of things really stick out here... 1) You are spraying what is referred to here at the CATT as "PINK DEATH" The 3355-11 is about the most active/aggressive flux you can get your hands on. I am concerned about both the condition
Electronics Forum | Fri Jul 13 11:33:54 EDT 2007 | realchunks
Just starting and already responsible for product quality and machine adjustment? Wow, you poor bastard. Ok, I will assume this problem happens on the bottom side of the board with a thru-hole IC. The short occurs on the side that doesn't have the
Electronics Forum | Mon Jul 24 02:01:22 EDT 2017 | tsvetan
This will depend on many factors: your reflow oven chamber size, your oven temperature controller, the speed of the conveyor, size and mass of your PCB, etc etc. In practice you should adjust the profile for each case if you want to set in the optim
Electronics Forum | Thu Jan 04 15:39:49 EST 2007 | realchunks
Is it a failure or a schedule overdue? If it's a failure check the vacuum sensor in the exhaust. You should be able to locate the straw and follow it back to the diaphragm. You can adjust the diaphragm. Or you can electrically jumper past it.
Electronics Forum | Mon Nov 14 00:13:55 EST 2011 | tpappano
Hi Jeff, I pulled the proms from both machines, copied to disk, re-burned the the old versions with the newer and reinstalled. The ram became scrambled in the upgraded unit on startup, but I did a full restore through the serial port and unit #2 got
Electronics Forum | Wed Feb 28 19:48:11 EST 2001 | davef
If we were talking about a single board problem, we�d be thinking about the laminate, but since you imply the problem is broad-based across multiple assemblies, consider the following machine parameters: * Crank-up preheat time / temperature to driv
Electronics Forum | Fri Jan 24 09:26:29 EST 2003 | pjc
I sent you a couple of charts to assist with your troubleshooting. One is the Electrovert Wave Solder Troubleshooting chart and the other is Sandia Labs/Electrovert Optimum Solder Contact Time. Electrovert has a 6 deg. conveyor angle standard on the
Electronics Forum | dilogic |
Mon Jun 27 14:27:47 EDT 2011
Electronics Forum | Mon Aug 27 12:31:04 EDT 2012 | rway
Its no my turn to give some advise. My first > question would be can you put the boards into a > carrier of some sort. There are many wonderful > companies that make carriers that are ment for > running down a smt line. This can be expensive > u
Electronics Forum | Sun Apr 15 20:58:17 EDT 2007 | darby
PCB > Origin > O* > Skip = No Data In > PCB > Mount > M* > Skip = No Data In > System > Parameter > Position > Waiting Pnt Check that the waiting point is not set at such a co-ordinate that the PCB sensor is seeing the gantry. The pcb sensor also h