Electronics Forum | Fri Mar 03 15:20:16 EST 2006 | Wave Master Larry
WELL if that isnt a sales pitch I dont know what that was.At my place of employment the engineering department tried to make us use this gizmo for our waveprocess and managment was made to beleive that this was the cure all for our shorts and skips.W
Electronics Forum | Tue Jun 19 11:28:10 EDT 2007 | kpm135
I am fairly new to the MYData machine. The TP11 we have just started generating the following error: W-MIPR-20:System voltage BATTERY measured 14.59V (outside limits). After talking with the operators and reading the manual I believe the problem may
Electronics Forum | Wed Jun 27 18:10:34 EDT 2007 | kpm135
Just thought I'd let you know the problem was the Batteries. There happened to be three 6 volt 10 Ah batteries hooked in series that were no longer holding voltage. Also we ended up replacing the MI board because there was a fried component on it. Do
Electronics Forum | Wed Jan 30 12:04:28 EST 2013 | caerleon
We have a device that uses the same technology of Li-Ion battery. We had a problem with charging and over charge part of the circuit. The issue was that the battery and the charger had the same inbuilt safety circuit to protect it from overcharge and
Electronics Forum | Thu Dec 11 02:24:37 EST 2014 | vladicac
We found out what was the problem. If you happen to get the same error be sure to check if you have access to all COM ports. Also check CMOS battery. Because of low battery voltage all BIOS settings were lost. Because of that we had to reconfigure ou
Electronics Forum | Thu Apr 09 08:22:19 EDT 2015 | bobpan
Sounds like the battery or batteries inside are dead. You can just plug the input and the output on the back of the unit into each other. The ups is not needed on the machine and was only used so that you can shut down the computer properly incase th
Electronics Forum | Mon Aug 31 06:26:44 EDT 2015 | piyakorn
Hi At our SMT mounting found battery clip stick in the reel pocket and some dropped under pick&place machine from the nozzle can not pick out the part which got recommendation should change the nozzle type from standard placement to be clip sho
Electronics Forum | Sat Mar 17 14:14:30 EDT 2018 | introlab
Hi . If the machine was not connencted to power ,the battery failed and the controllers exec was lost or corrupted. Check the bettery on J11 controler ,if it is dead this is the case. Change the battery and reload the exec. There is an exec file
Electronics Forum | Sun Oct 21 22:05:01 EDT 2018 | srini1904
Hello, We have Dek 248 Icon i2 semi auto screen printer. This machine was not in use for long time and Bios battery was dead. We replaced Bios battery and now date are correct. Issue is its not communicating to control board. Suspecting Bios setti
Electronics Forum | Tue Oct 26 20:02:48 EDT 2021 | astarotf
Yes Deni, we just found the battery on the EPC-5A board. I was wrong, because of my ignorance. We have the EPC-5A board, this one allows us to have a larger capacity disk, currently we have a 1705 MB seagate I hope after mounting this battery to be