Electronics Forum | Tue Jun 30 12:06:04 EDT 1998 | Michael Fogel
| | I have a 2-up panel measuring about 8" x 8" with a score for depanel throuch the middle. I see warping after reflow of the panel (bending in/about score line). The board is not framed (i.e., supported) during SMT reflow other than on the conveyor
Electronics Forum | Wed Aug 15 16:36:06 EDT 2001 | sharafali
How is a squeegee considered damaged? Is just a bent blade sufficient to call it 'unfit for use'. How much bend, in a blade may be considered unfit? How much do dents on a blade affect squeegee perfomance? what is the effect of blunt blades on print
Electronics Forum | Wed Mar 06 06:47:00 EST 2002 | francoiscal
Hello, Does any one as a database regarding component assemble by hand on a PCB. More accuratelly how much time (per sec) does it take to bend leads on a component(res), time to insert the component by hand, time to solder by hand. Any time base dat
Electronics Forum | Thu Mar 14 09:21:38 EST 2002 | davef
You should be looking for a better method of depaneling your boards. Listen. If you breaking components, it's not the component. It's you. Either you are: * Applying too much force. * Bending the board too much. * Locating the components too clos
Electronics Forum | Tue Aug 10 06:58:48 EDT 2004 | dka123
dear all, kindly guide me for the use of space electronics hardware assembky of PQFPs and Cqfps, how to form the flat pack leads, bend for 240 pins of 20 mil pitch and what are the Mil standards for them.how to cut the lead guards.can we use FP5 elit
Electronics Forum | Fri Apr 08 13:55:05 EDT 2005 | chrispy1963
Grant, Yes they do get broken by the operator or whom ever is loading or unloading the feeder stick pulling the tape through the feeder and the component pocket will snag the tip of the plow and bend it so that the tip ends up breaking off making
Electronics Forum | Mon May 09 17:49:28 EDT 2005 | chon
Inspect the cables specially in those area where cables have bendings with the motor motion. If they have something covering them or extra insulation try to remove it and inspect closely. If the machine runs and suddenly stops with this error and aft
Electronics Forum | Fri Oct 14 12:16:14 EDT 2005 | bschreiber
Be careful when using compressed air, it will not only �blast it all into the air you breathe�, it can also damage the stencil by bending the delicate land mass areas of fine-pitch apertures. I recommend the article �SMT Stencil Cleaning: A Decision
Electronics Forum | Thu Oct 20 06:03:23 EDT 2005 | Slaine
during the soldering process on larger BGAs the corners can bend up or down due the large copper heatsink on top expanding quicker than the material the bga is made out of, in the worst cases this can lead to to the balls lifting out of the paste and
Electronics Forum | Tue Dec 13 10:27:46 EST 2005 | patrickbruneel
Samir, This growth doesn't look like a tin whisker which are needle like and very fragile (they don�t bend they break). I have seen similar growth in the past in an EMS defect analyses with connectors in stressed conditions. The growth seen was sim