Electronics Forum | Fri Jul 28 11:48:55 EDT 2006 | Rob
Sorry Chunks! Not really with it - Friday afternoon, with 10 minutes to go. From experience I'd go with termination coating problem, linked a a few values, as they batch coat by value - so a 220R may be affected, but not a 100R.
Electronics Forum | Sat Jul 29 08:52:09 EDT 2006 | davef
This recipe is nice for leaded soldering. The time above liquidous plus 20*C is too short for mixed alloy soldering. Remember all that nonleaded stuff that you add to the solder acts to increase the liquidous temperature of the alloy. Try slowing
Electronics Forum | Mon Jul 31 15:03:38 EDT 2006 | kris
Did you try a different lot of components or a different vendor of the components to see if the problem remains ?
Electronics Forum | Wed Feb 28 14:25:39 EST 2007 | Brandon
Has anyone here had issues with Titan's (Board house) Leadfree / Rohs compliant boards blistering at lead free temps? MAX temp 250c thx
Electronics Forum | Sat May 02 08:48:32 EDT 2009 | davef
You have a board defect. Any moisture and/or organic contaminants trapped by the solder resist during lamination may cause solder mask delamination, blistering and/or adhesion loss during subsequent soldering operations or during extended use.
Electronics Forum | Mon Sep 14 08:07:24 EDT 2009 | davef
You have a board fabrication defect. Search the web for "hole wall pullaway" Performing a microsection is the best way to analyze the defect.
Electronics Forum | Fri Sep 18 09:22:03 EDT 2009 | ysutariya
Don't forget the possibility of excess moisture absorption. If this is lead free, then the laminate manufacturers state that you should bake prior to assembly. Was this completed?
Electronics Forum | Mon Oct 26 12:40:08 EDT 2009 | awtm
pls find attached photo from Supplier saying that the failure at pth hole was due to blistering caused by moiture evaporate rapidly resulting delamination occur on FR-4 material from an old PCB (3yrs). Pls advise if attached picture confirms such co
Electronics Forum | Sun Oct 01 23:58:55 EDT 2000 | stuartfd
Dear forum types, 1st timer so be good. I have a customer in China using Coates soldermask that in its self is not a problem. The problem is the flux their using, I think,it appears to have a vary high viscosity. The problem they have laid at my door
Electronics Forum | Tue Jun 13 04:46:15 EDT 2006 | AR
Has anybody else noticed a problem with Assembl�on's mechanical 12 mm feeders, with 4 mm pitch? We are experiencing grave pickup problems with a MELF diode packed this way and fed with this type of feeder. If I attach a hefty weight to the blister ta
