Electronics Forum | Wed Jun 18 19:26:39 EDT 2003 | gregoryyork
Rules of thumb :- 1. Never over flux - not necessary and waste's money. Never top flux neither 2. Top Board temp. around 70C - 105C or there about's pending what laminate you use. Obviously the more flux you apply the higher heat required/denser PC
Electronics Forum | Thu Oct 12 16:55:19 EDT 2006 | realchunks
This type of testing is only done to verify your reflow process. It is destructive testing and should not be performed on product reaching your customer. Solder is only used to provide the electrical connection from part to board. As a metal it is
Electronics Forum | Wed Apr 13 12:10:47 EDT 2022 | winston_one
Hello! We have a strange effect. Some pads of big trough-hole DDR slot just dessapear. Initialy it was soldered with selective soldering process (leaded, 290 degrees, ImSn finish, very short storage). Then some connectors with poor barrel fill we hav
Electronics Forum | Thu Jul 09 21:31:07 EDT 1998 | Dave F
There's a company out the that makes air sleds for moving equipment around. Air sleds are heavy duty plastic plastic bags with lots of little holes in the under-side. The bag is positioned under the equipment. A vacuum cleaner, hooked-up backwards
Electronics Forum | Thu May 30 12:27:25 EDT 2013 | ericrr
I was more interested to read up on paste, As for the short run of 50 panels was finished, the panels dribbled out slowly. about three times the second day I took off the paste, mixed it up and put it back on, seems to do the trick. Also I gave ea
Electronics Forum | Thu Sep 30 03:17:45 EDT 1999 | Brian
| Hi everyone, | | Greetings! | | I�ve got a 2-layered through-hole PCB�s having the following problems: | | Solder Mask peels after wave soldering at random locations and only at the bootom side of the PCB | Insufficient Solder and some solder ne
Electronics Forum | Wed Mar 20 14:54:15 EDT 2024 | linux
Vacuum Low, Shows up on changeover when the head picks a different size nozzle, remove mesh filter, unplug the clear pipe from the top of the head, put a small amount of alcohol down the pipe and blow it out with the air gun, You should check for a h
Electronics Forum | Fri May 10 01:42:13 EDT 2019 | vinitverma
A Table is something that you can ignore right now. It is significant only in case of dual table machines such as Sapphire or Sapphire-X which have A and B tables (two independent PCBs being handled at the same time). In case of Topaz or Topaz X or E
Electronics Forum | Sun Aug 15 11:02:37 EDT 1999 | Jeff Ferry
| Ladies and Gentlemen, | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav tremendous
Electronics Forum | Sun Dec 09 22:54:20 EST 2001 | dburr
It sound you have already discovered to root cause, flux entrapment in the via holes. Short of changing the desing, here are sone suggestions. The main thing is you have to dry out the via holes of the wet flux. Some things to try are: slow down t
