Electronics Forum | Wed Dec 10 15:45:02 EST 2003 | Carl
If your operation is hi-mix low-volume, consider > taking a look at some of the bench-top units out > there. They are lower cost but can give similar > performance as higher cost in-line systems. Some > of the bench-tops cannot do solder fillet
Electronics Forum | Sat Apr 15 11:18:58 EDT 2006 | oldtech
I once had a problem with the fid camera that caused this problem Try turning on the fid camera and align the cross hairs over the tooling pin or any stationary object. lightly tap the edge of the light housing with a alan wrench if you see the cro
Electronics Forum | Wed Feb 02 23:28:48 EST 2022 | cbeneat
Something we've run into in the past, not on those machines, a different brand completely, and I have no experience with yours. We were having what you described and what we found was during the part being scanned, there was a bolt that held the shro
Electronics Forum | Thu Aug 16 14:32:18 EDT 2012 | nicodj77
Hi, AOI CR RTI 6520 Need help to find the part# or alternate for those little Light Bulbs that are located on the 6 panels around all the cameras, it looks like a Led but I think it's just a bulb, not sure. Thanks!
Electronics Forum | Sun Jul 20 14:55:25 EDT 2014 | bobpan
Typically when this happens the lighting in your package for a part in one of those cycles has 0 0 0 in the 3 light settings. You need to check all your package types that are used in your program and makes sure they are adjusted correctly. Good Luc
Electronics Forum | Wed Jul 16 18:08:11 EDT 2003 | mgershenson
OK, disclaimer; I'm a salesguy, but I was a process engineer for quite a lot longer than I've been in sales. Your question is very vague, and may be difficult to answer. There are many ways to configure AOI to inspect solder, but as has been pointed
Electronics Forum | Thu Feb 15 13:46:16 EST 2018 | aemery
Griinder, Maybe it's me, but I think what you might be saying here is that you see a reflected image of the PCB or Stencil when you and teaching the fiducials and it is interfering with the teaching routine, is that correct? If this is true it is c
Electronics Forum | Fri Sep 19 13:22:33 EDT 2008 | evtimov
Hi, if it is for all your products, for me it looks like a camera cable or camera problem. You are loosing connection and get the message. FFFC looks like a fatal error. If it is only one product, play with the lighting and treshold. Regards, Emi
Electronics Forum | Sat Sep 26 21:45:37 EDT 2009 | casmt
It didn't see the ref points on the bottom of the hydra head. start by checking the camera for dirt or dropped parts. Is it a hydra camera or Linescan?
Electronics Forum | Fri Nov 30 18:22:40 EST 2007 | mika
Hi Paul M, There are no silly questions but silly answers.. and here is maybe a few if I understand you correctly: If you consider place anything less than a 1.27mm (50mil) pitch component down or a chip less than a 1210, hey it maybe don't even work