Electronics Forum | Mon Jul 30 17:31:59 EDT 2018 | dekhead
That error message is keyed by a hardware (soldered) link on the backplane board of the Y1 (motor controls), through direct cable to PCIB40#3... check connections both ehds; possibility of multiple PCIB failures?
Electronics Forum | Wed Apr 03 09:00:01 EDT 2019 | jfmahe
Hello all I'm looking for TAKAYA 9400 motors: y:P50B04006DXS4RE SANYO DENKI X:P50B05010DXS4RE SANYO DENKI Z:RB2451AT104 SANYO DENKI Thanks for help. J-F
Electronics Forum | Tue Feb 28 22:32:38 EST 2023 | cbeneat
it looks like the table is in contact with the Y1 switch. If you can remove the cover, the motor is the R/H one. Turning the belt will move that side of the table. I'm going with the assumption that an X4 is close to an X5.
Electronics Forum | Wed Feb 04 23:27:38 EST 2004 | dougt
I did some work with 400E's and have can give you a couple things to try with your Y axis problem. 1. There is a file called stepperparms.exe that will load all the stepper parameters on the PCL IC's. Your y axix chip may have corrupt data on it.
Electronics Forum | Sat Mar 25 16:01:08 EST 2006 | gipos
Dear all, Please help me to find out where we can find a Z axis camera motor for Panasert SPP A- M (NM 2624F)paste printer ?? Thank you Mike ZIG
Electronics Forum | Thu Oct 02 01:59:06 EDT 2008 | edmaya33
Obviously nobody can help you Jack. 1. its the camera for parts recognition ( enhanced CMOS ). 2. positioning system upgraded from ball screw to linear motor/gantry. before CPH=16500 new CPH=18000 using H12S
Electronics Forum | Mon May 13 10:08:44 EDT 2013 | rgduval
I've heard that MyData is no longer supporting the TP's, so, getting a new motor might be a difficult proposition. If you can find the motor manuf/part number on the motor itself, you can likely find it on line somewhere...Google the p/n should do i
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Fri Nov 14 10:56:12 EST 2014 | max83
We are working with SMT lines consisting of > machines opalxii after 5/6 years of operation > have appeared problems in operation of the > engines on the x and y axes. I disassembled the > engines from the machine and I removed the cap > that c
Electronics Forum | Fri Sep 09 10:43:58 EDT 2005 | ???
sounds like the part is being picked up on its side....which means.......it could be.... 1. pickup not taught correctly -- X-Y- or Z 2. head to camera calibration is needed 3. or least likely....feeder problems