Electronics Forum | Tue Jul 13 05:21:04 EDT 2010 | bubbobbed
Guys, I've received complaints from customer that the chip is sticking on the cover tape or carrier tape when detape. Is there any possible that i can solve the problem by changing the cover tape or carrier tape?? some say the root cause of this issu
Electronics Forum | Sat Dec 01 13:51:26 EST 2012 | anvil1021
In my experience with flex the flex provider is the best place to go for these pallets. The competent flex and rigid flex providers will also provide the carriers if requested. Once you see what they are providing you, you could most probably make th
Electronics Forum | Mon Jan 21 09:29:33 EST 2013 | cnotebaert
I agree, you will likely need a carrier being that thin. without seeing the trace layout I’m not sure about relieving the carrier to accommodate them. if evenly distributed you shouldn’t to go that far. Are parts on both sides of the board? Don’t mak
Electronics Forum | Wed Jul 17 11:26:19 EDT 2013 | pbarton
What equipment do you have? As well as the comments from others, another major influencing factor can be the residual heat in your PCB carrier. It takes more heat energy to warm a cold carrier than if it is already hot from the last cycle run. This
Electronics Forum | Sun Dec 20 08:15:15 EST 2015 | dilogic
Generally, that should not be a problem. Software for this purpose is pretty simple, the main issue is how accurately pcb carrier will be positioned at both ends. This is purely dependent on printer's mechanics. I have an old DEK247 and thought about
Electronics Forum | Tue Aug 01 09:27:13 EDT 2017 | tmennink
Hi all, We are having a lot of trouble with mis-pick trying to place silicone dome LEDs(3535 package) It seems that the silicone of the LEDs is sticking to the side wall of the carrier tape pocket. The vacuum nozzle would normally suck up the led an
Electronics Forum | Thu Aug 03 20:51:27 EDT 2017 | OrHorti
I did a test where the leds were put into a 95% humidity at 60 degC environment for an hour, and after that almost all leds would stick into the carrier tape. So, moisture might certainly play a major role in the stickiness of the leds. We placed al
Electronics Forum | Sat Oct 27 14:57:00 EDT 2018 | jacobidiego
Hi Experts, I have noted a savings opportunity on our work-place as chipmounters discard carrier tapes which are easily separated in different waste-containers below the feeders. Normally the company pays a service to dispose that waste. Have anyon
Electronics Forum | Fri Nov 15 22:05:09 EST 2019 | alanyang
Flexible circuits assembly is different from rigid board assembly. For some manfacturers, fpc assembly are some things more painful because the assembly quality is unstable. Recommend to check and hope these 2 blogs are helpful. Flexible Circuit Asse
Electronics Forum | Tue Feb 09 19:04:08 EST 2021 | jzeivel
Thank you for your reply! I will see how it goes without the carrier pallets. I was worried about them drooping too far in the center (at the center V-Score) and falling off of the conveyor in the reflow oven. I am putting boarders on all sides of