Electronics Forum | Fri May 04 05:26:20 EDT 2012 | mrross
We do this If you shut down without cooling first it could warp the chain
Electronics Forum | Tue Aug 23 14:25:50 EDT 2005 | pjc
Here's the oil: BIO 30 - Biral Industrial oil (operates to +300�C ) BIO 30 is an extremely high quality synthetic industrial oil for a wide number of applications. BIO 30 leaves no carbon deposits and is highly resistant to oxidation. An outstandin
Electronics Forum | Mon Aug 13 05:56:39 EDT 2007 | chrispy1963
This may sound silly to ask, but does your oven have a center board support by chance? If so is it down when running the boards through the oven? I only ask this because we had the solenoid that operates that function (raise and lower) of the board
Electronics Forum | Thu Mar 04 19:27:33 EST 2004 | russ
what I have usually found although not from wave conveyor chains but from racing motorcycles is that binding is caused by wear and bending and not dirt unless it is excessive to the point that you can actually see the dirt that is binding it. When t
Electronics Forum | Tue Jul 15 09:02:09 EDT 2008 | ehess
Has anyone using these ovens had any problems with the chain (flat) belt slipping? I suggested to the tech we remove a link in the flat chain, and he responded it would make it out of warranty. It's the same type of chain flat belt as most wash and
Electronics Forum | Thu Jun 30 10:27:25 EDT 2005 | cyber_wolf
Ryan, I have never seen an oven "blow" parts off the pads. Whenever I have seen parts come off the pads in the oven, it was because the mesh conveyor or edge chain was jumping a sprocket tooth.
Electronics Forum | Wed Aug 03 11:08:24 EDT 2005 | PWH
We use the following stuff from "Biral USA": BIO30 Synthetic High Temp Oil � Chain Oilers NMG-400G � No melt grease - miter gears/lead screws AS500ML � Anti-size spray - lead screws, drive sprockets, rail support L-brackets It seems to work good
Electronics Forum | Tue Jun 22 22:26:12 EDT 2004 | pdeuel
we keep some extra chain belt that is used in most washers and reflow ovens. We have not had any problems. Our wash has slightly more pressure comming from the top nozzles than the bottom nozzles. same for the air. This will hold the boards down in t
Electronics Forum | Mon Mar 20 08:36:30 EST 2006 | jdengler
I've never had this problem on an Omniflo oven, but have seen it on others. It has always turned out to be mechanical. A bearing going bad or FOD in the rails. I would pull the chains and carefully check each link of both chains, all of the bearin
Electronics Forum | Tue Mar 21 07:31:54 EST 2006 | cyber_wolf
We had the exact same problem on our OMNI 10. We found that two of the rails the pin chain rides in were warped. Somehow at one point our PC lost communication with the oven and the heaters went wide open for several minutes...this is what caused th
