Electronics Forum | Wed Dec 27 10:55:47 EST 2006 | SWAG
I don't know much about BTU but we had a very similar problem with a Conceptronics and it turned out to be one of the 120V power supplies. Our machine had two of them (the same as you would find in any PC). Easy to test them although they can be fl
Electronics Forum | Fri Nov 30 17:13:36 EST 2007 | stevek
Not sure about that model, but I've used several DRS 22's and find them easier to use than the DRS24 I inherited at my current place. The lack of automation makes doing things yourself easier. The newer automated machines need more programming. I'
Electronics Forum | Tue Dec 11 16:55:11 EST 2007 | dman97
Hi, I am using a 7 zone Conceptronics oven and Indium 3.1 lead free clean paste. Our profile is as follows, 130 140 150 180 200 240 260 with a belt speed of 36 inches per minute. I dont know if that will help you out though...
Electronics Forum | Fri Jul 24 11:56:24 EDT 2009 | stepheniii
I've had the relay that controls closing the lid go bad It's a solid state relay if I remember correctly. Are you talking about a motor driven lid? edit now I"m trying to remember if that place had conceptronic ovens and that's what I"m thinking of
Electronics Forum | Sat Apr 25 11:37:56 EDT 2015 | ercdave1
DucHoang, thank you for your reply. as you mentioned I checked the solid state relays on the input and output side. I did get power coming out of all even when the conveyor was stopped. I will mark them with their position and swap some to see what h
Electronics Forum | Thu Jul 02 15:27:19 EDT 1998 | Justin Medernach
| | Looking to contact some users of Vitronics reflow ovens. | | Which model do you use? | | Overall opinion of equipment and company? | | Thanks in advance | Where in the world is Steve Dow when you need him? Steve was one of the pioneers at Vitroni
Electronics Forum | Sat Jan 10 15:19:28 EST 1998 | Jon
Check out the web site www.conceptronic.com I think you will see that the Conceptronic ovens are the best and most reliable over the long haul. Micron CMS has over thirty five of them and has stated that they were the most reliable and best vendo
Electronics Forum | Wed Jun 13 16:20:33 EDT 2001 | Gregory Stanton
Does anyone know of a quick method for developing reflow profiles for a Conceptronics HVA 102 reflow oven? Our plant is exceptionally busy and it's difficult to get access to the machine. I've been told by a few folks the oven has enough zones (7)
Electronics Forum | Wed Jul 04 14:22:51 EDT 2001 | davef
I just rooted through an analysis that we did five or six years ago [so current it aint] and finally found the goods. We talked to Vitronic, Heller, Electrovert, IR, and Conceptronic. Only Electrovert had a 2.75" throat [rail to top of board cleara
Electronics Forum | Thu Aug 16 15:29:30 EDT 2001 | steven
When Air-Vac introduced an IR system at a show in San Jose, people though it was the greatest thing since sliced bread. For obvious reasons they discontinued the short life of the IR systems and implemented hot air into their rework stations. Sales
