Electronics Forum | Wed Aug 26 04:31:20 EDT 2009 | prasadz
In XP142E very often we are exprencing the R Axis Servo error. When we reduce the Speed to 0.5 it becomes OK. Any body can give solution for this.
Electronics Forum | Fri Feb 10 12:21:20 EST 2023 | youngbuck
Also, tried swapping the Servo card. X7 which is the Rising table servo motor card, swapped with X8,9,10 which are all the same and same result.
Electronics Forum | Fri May 06 15:15:19 EDT 2005 | lyrtech
Hi, I have an INTERMITENT error on my FUJI IP-2 that cause to me many headaches. The error is " SERVO NOT GOOD". In the books, it means that it is relative to servo amplifier. But I can't assume that is the problem because sometimes the machine wor
Electronics Forum | Wed Dec 13 08:54:28 EST 2017 | raymccomb
We have a DEK 265 and we have fitted new belts to it after one split in use. when we set back up and run program A all is OK, when we go to run program B it has System Error. Servo Following Error - Fatal Error - Reinitialise machine. Does any one h
Electronics Forum | Thu Aug 05 20:33:48 EDT 2004 | Dhanish
The machine type is Fuji CP6.We have major issues with Network Resistor placement.The equipment guys often feedback there is a problem with nozzle and feeders.What will happened to the part if the Thickness data in the Part Data does not match the Pa
Electronics Forum | Fri Jul 17 07:50:32 EDT 2009 | csm
Dear Jepoy We check the oilmatic system and I found a relay is not working, it will arrive until tomorrow. We still have 2 errors and 1 message, we are taking time because we don't have the Fuji CP6-4000 manuals or electric diagrams. we get this ma
Electronics Forum | Tue Jul 17 15:26:08 EDT 2012 | kruzer
Hi I use CP4, CP6, CP643, GLV and NXT, but i have a problem with CPIV, i cant use It with Director Fuji Flexa. i use snifer rs232 (rs232mon) to resolve problem and what i know: Computer send on rs232 to machine (every 1 min or something): vQN2105
Electronics Forum | Fri May 06 16:19:40 EDT 2005 | jdengler
Does the problem happen at start-up? Does the servo amp have an error? If yes to both, could be a bad cable, or a badly tuned servo amp. If after running and the amp has an error it could still be the cable but also brings in things like a bad motor
Electronics Forum | Thu Jan 19 06:39:56 EST 2006 | dougs
It's been a few years since i worked on a CP machine but your st17 & 19 errors are probably down to grease in the clutches at the top of the shafts, if too much grease is put onto the turret gear during maintenance it tends to spray into these clutch
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would
