Electronics Forum | Mon Sep 20 13:43:40 EDT 2010 | dman97
Hi, Yes I dont have any estops engaged. Like I said, I can press the system switch and I can hear the locks engage, but it will not give me an option to lower the hood. I have tried turning the maintenance key, but nothing shows up on the monitor.
Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom
Electronics Forum | Thu Feb 22 23:27:14 EST 2007 | dekhead
If protocol is already manual, does conveyor start when "RUN" is pressed (without board on rail)? Or does it not start until board is placed? Try running UL protocol as "No FMI", put in run without board on rails, place board, press "Confirm". Board
Electronics Forum | Fri Feb 23 08:51:38 EST 2007 | dekhead
Are you saying that it works in "no fmi" mode, but not in manual? Please tell me how it works in both. I'm asking you to change things to ascertain the problem, not as possible solution... if you can't get the board to stop in the correct position,
Electronics Forum | Mon Dec 08 13:59:54 EST 2008 | floydf
Would anyone know the differences between a DEK 265 LT, DEK 265 GSX and a DEK 248? Thanks.
Electronics Forum | Wed Feb 09 09:59:25 EST 2005 | aj
Randy, We have a Dek 265GSX and 265 MK1. We print 20thou pitch components, 0.5mm. Just make sure you have good board support and USC. aj
Electronics Forum | Sun May 02 17:58:21 EDT 2010 | bruceb
When my DEK 265GSX boots I get a vision error1 and am asked to reinitialize. I cannot get into mainenance mode to troubleshoot. DEK told me over the phone that I have a bad Cognex card and it would be $20k to repair. This is crazy, has anyone seen th
Electronics Forum | Tue Nov 07 06:06:57 EST 2006 | Tyrone Hudish
Use a Ekra printer!
Electronics Forum | Thu Feb 22 20:35:54 EST 2007 | dekhead
Your vocabulary is improving Tim
Electronics Forum | Thu Feb 22 21:52:43 EST 2007 | vshan
but the problem is the stopper comes down only after the board pass thru rgd vshan