Electronics Forum | Thu Jul 21 22:22:50 EDT 2005 | Ken
Hey, Peter. back in the mid 90's I reversed engineered their drive system because of a dispute over print speed malfunctions. I prooved correct that they had made published claims about their drive topology that were not true. They agreed to redes
Electronics Forum | Thu May 16 04:54:33 EDT 2013 | aj
Hi all, I have an intermittent problem on a 265 GSX printer. "Position error" on the rising table.. quite a lot of work has been done with no success. such as motor, break , encoder replaced....diagnostic checks etc.... Machine could run for a few
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Wed May 03 08:43:51 EDT 2006 | Mark Fick
I have a DEK 265 with error code: motor comms failure.card 0, Axis123 fatal error-reinitialize machine during machine boost up I replaced new card 0 and still get the same error.I have tried to load the mint program but I cannot get program to abort
Electronics Forum | Tue May 03 16:36:09 EDT 2022 | dwl
I don't know anything about DEKs so while you wait for a more informed response, here are a few brain droppings... Did something get knocked loose on the camera assembly? give everything a wiggle test and make sure it stays in place. Is the encoder
Electronics Forum | Thu Jun 23 13:50:07 EDT 2005 | Erik
Paul, I'm quite frankly relieved, I thought I was the only one with these thoughts! We have only had our Rheometric pumps since February, but since then our process has been difficult to control with fine pitch applications. And then there's always
Electronics Forum | Thu Mar 22 10:07:48 EDT 2012 | hussman
We chose the MPM over the DEK. We did real world comparison in our factory with both machines almost side by side last year. MPMs offer a real windows based software that basically takes the operator out of the equation. Besides the basic screen p
Electronics Forum | Fri May 08 17:12:00 EDT 1998 | Justin Medernach
| I am writing a report about screen printing. | Does anyone know where I can find information about | screen printing and screen printing machines? Pete, Try www.dek.com and www.mpmcorp.com These guys are the biggest automatic printer mfrs. in th
Electronics Forum | Fri Jun 12 05:16:48 EDT 1998 | M. Fajar Nur Arief
| | I am writing a report about screen printing. | | Does anyone know where I can find information about | | screen printing and screen printing machines? | Pete, | Try www.dek.com and www.mpmcorp.com | These guys are the biggest automatic printer
Electronics Forum | Tue Mar 02 17:26:24 EST 2004 | pjc
I worked on MicroFlex. All axis move via electric motor drive. Carraige reapatability is +/- 0.0005" (12 micron). Cameras position more easily on linear bearings than the swivel type. The alignment accuracy and repeatability easily supports sub-20mil
