Electronics Forum | Thu Sep 22 10:31:23 EDT 2005 | johnw
Geeze never thought all you guys cared about us Europeans so much We only come here to help you guys out lol
Electronics Forum | Fri May 14 12:40:03 EDT 2004 | Kuru
My switch is good, I can check the switch and the two photo sensors on the input test screen. They are turning on and off.I can see it no the board too. When I start up I can see Tactile unit come down so I know pneumatics portion is good. I am still
Electronics Forum | Wed Nov 03 16:35:03 EDT 2021 | smtusa
We are big mpm fans especially the UP2000/2500 dos based. I just got an MPM SP2000 but feel thats too big. I would like something even smaller for an office setup. I looked up the MV100 and it came up with a pic of Quad. It looked pretty big in p
Electronics Forum | Tue Apr 27 14:54:26 EDT 2004 | Kirk
reduction apertures in stencil and question how find center?. I thought that vision start playing important role at the beginning for the first PCB, help set precisely printing process. You gave tip to work without Mylar. Ok but again how you set ste
Electronics Forum | Thu Apr 29 15:05:29 EDT 2004 | Kirk
we have sm-tech benchmark 90 and we think about Microflex with vision. how i teach the vision? I have two images. One is reference image and is it storage in system how can i create it (is it possible simply use paper as i said before then teach vis
Electronics Forum | Wed May 05 01:42:06 EDT 2004 | fastek
Kuru- If you have a bad tactile sensor....find out what the part number is and you can order it from MPM. If you don't have the part number, MPM won't help you unless you pay a price to register the machine. You're other solution is to post an ad on
Electronics Forum | Thu May 13 16:54:55 EDT 2004 | Kuru
I just installed a used Tactile sensor unit, Now it now reads error "Tactile Sensor sensor never closed". If anyone knows or seen this problem pls help. I have adjusted the flag on the photosensor.The photosensor appear to be functioning but the step
Electronics Forum | Thu Apr 29 10:49:05 EDT 2004 | pjc
Yes, using an illuminated magnifing glass helps. How well your board fixuring is on the table will effect print alignment on other boards loaded. 0.5mm & 0.4mm will require very good fixuring, like you can get with tooling pins if the board has non-p
Electronics Forum | Thu May 13 23:01:07 EDT 2004 | fastek
Unplug the tactile sensor and check the switch with an ohm meter. If the tactile sensor switch is good go in one of the drawers in the back of the machine and with the help of your schematics find the opto-module that controls the tactile sensor circ
Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
