Electronics Forum | Thu Jun 22 03:27:08 EDT 2006 | dman97
Hi everyone, I was wondering if anyone knew of a backdoor setting in these machines that will allow you to change the machine configuration. At my company, we have one operator who decided it would be nice to lock everyone out of the user menus. He
Electronics Forum | Tue Sep 26 11:58:56 EDT 2006 | lheiss
Thanks for the responses everyone. It seems that the main problem was that the extent data wasn't set up right in Central Controller. I deleted it from the Pickup and Place files and it started placing things without correction. I only had about 1
Electronics Forum | Thu Feb 08 17:10:18 EST 2007 | slthomas
I thought we were already registered? No? Shows how long I remember stuff. Providing a confirmation link to the site in an email to the new registree seems like it might provide some security and deterrent to low-life spammers as well. Over and abov
Electronics Forum | Thu Mar 08 06:30:48 EST 2007 | tommyttr
Chris, The machine is looking for a response from the LC. Usually, it will hang up from a corrupted .gf file. delete all the .gf files from the station. make sure you are NOT hooked up to the LC and/or LC turned off, put machine in stand alone mode.
Electronics Forum | Thu May 17 03:52:34 EDT 2007 | kevinjm
Hi lads, I have a problem with asequencer 2596. We had a power cut last week which cut power to the seq. The battery on the controller box was dead(now replaced), which meant the exec file got deleted from machine. Now I can't load it back up again.
Electronics Forum | Wed Aug 22 21:49:33 EDT 2007 | darby
Steve, I thought these were the same format as the CSM, or very close to it. If so, then your *.BRD file has MNT#, X, Y, R, Nozzle-Skip-Feeder#- LocalFid, Designator, Part. Get rid of the header down to MNT = In Excel parse the file so that you get
Electronics Forum | Thu Jun 26 13:56:52 EDT 2008 | wavemasterlarry
LISTEN i dont appreciated the forum removing my good advice.last I checked this is the free country and we have the right to be heard and LISTENED to. i consider myself tops in terms of valuble advice given here and in a sense I'm giving folks free c
Electronics Forum | Sat Feb 16 22:19:11 EST 2013 | mdang
Hi, I bought a fuji Flexa v4.6.0.7 and hook it hook it up with CP65 machine. The flexa system already have CP65 configure so I can see the production program on the machine and delete them but I can not transmit a new program to the machine. It error
Electronics Forum | Mon Mar 11 04:57:31 EDT 2013 | bobpan
You really should edit your programs in central controller where it is much easier to follow the commands shown and to follow the extent data to see whats attached to each part/pickup. The hht can quickly cause issues when the wrong button is presse
Electronics Forum | Tue Feb 04 03:22:15 EST 2020 | tamasmagyar
You can do some changes on the fly on the machine, but is very limited. Like deleting a board from the panel, modifying offset, modifying fiducials etc. The thing is, I have issues with the programming interface, because the crashes and errors I get