Electronics Forum | Tue Mar 07 11:13:04 EST 2006 | pjc
One difference with ECD from a hardware standpoint is that the M.O.L.E. installs into the OvenRIDER, WaveRIDER and ReworkRIDER products for solder machine process control. You get the same software too. Competitive systems I believe require more hard
Electronics Forum | Thu Jun 01 17:24:48 EDT 2006 | flipit
Hi, I spoke to Kic about this at the Apex show in Feb. They told me it was OK to use the Orange Monkey Fur box for lead free. I even asked about my old side kic and they said it was OK also. I guess it depends on how high your temps are. I agree
Electronics Forum | Thu Mar 02 17:32:09 EST 2006 | sphilips
The initial cost of the battery is similar to saying the size of an iceberg is measured only by what shows above the waterline. There is a lot more to it than at first blush. The ECD Power Pack costs $245, but provides over 3500 hours of profiling.
Electronics Forum | Mon Jul 29 17:03:03 EDT 2002 | burb1999
Just setting up a new SMT line and have questions on which profiling product to use. So far the two in consideration are Super M.O.L.E. Gold and Slim KIC 2000... Please share any thoughts, experiences you have had with either and your opinion....
Electronics Forum | Tue Feb 19 09:41:26 EST 2008 | slthomas
ECD sells the MOLE, and they sell both the Oven Rider and the Wave Rider to accompany it. The thing is, you can profile both an oven and a wave machine without either if you're willing to just solder your thermocouples to a board. The nice thing ab
Electronics Forum | Mon Jul 28 14:30:22 EDT 2008 | grics
Take a look at this. Remember, these are only guidlines and can not replace any paste specs. As Real Chunks said, a profiler will be of HUGE help. We use this to determine what our top side temps are and to see if we have any problems with heat sen
Electronics Forum | Wed Sep 22 14:13:27 EDT 2004 | pjc
IN: 120VAC 60Hz 5W Out: 9VDC 150mA
Electronics Forum | Wed Nov 25 21:23:29 EST 1998 | Dave F
| I like to know under what conditions the reflow profile of a solder paste is taken? Bare board, board with the solder paste, or board with high melt solder paste? | John: None of the above. The two key variables that determine the reflow tempera
Electronics Forum | Fri Mar 19 07:24:29 EST 2004 | pjc
Before "Pb-Free" became an issue we were and still are using Pb-Free component lead finishes- such as on many TSOP, SSOP and QFP packages as well as caps. Components manufacturers changing the lead finish to no-Pb tend to ensure solderability with Sn
Electronics Forum | Thu Sep 23 15:26:30 EDT 2004 | Tarheel
Ours says Model: WD1D200KCN Input: 120 VAC 60HZ Output: 9VDC 200mA Class 2 Transformer Power Supply E31-0900-25 Electronic Control Design, Inc. Milwalkie, Oregon USA