Electronics Forum | Thu Nov 21 20:23:26 EST 2013 | dandin87
We have a Speedline MPM UltraPrint 500. The Hard drive currently in it has bad sectors, and so I had tried to install a new hard drive and used the installation folder from the old one to re-install SigmaPro 32. When I start it fails to find the Mete
Electronics Forum | Fri Jul 18 10:10:21 EDT 2014 | proceng1
We've got an MPM Accuflex printer that generally works great, but we've had a recurring problem. The powered rail (rear rail) fails to initialize. Sometimes all it takes is restarting the machine to get it to work. At the suggestion of the repair
Electronics Forum | Wed Apr 20 13:13:20 EDT 2016 | ttheis
Hi Guys, Yesterday one of our two gsm1 machines just stopped moving and let down the board mid-production. The epc computer continued to respond but no messages were displayed when palming up or down. I tried local IO and it said no IO was configure
Electronics Forum | Tue May 26 23:42:20 EDT 2020 | smiran082
Hello, I am having trouble the QSV-1 PNP machine. On boot it had trouble connecting to the RT computer as it was hung on a message saying something along the lines of, "Establishing connection to RT computer". After several restarts we still could
Electronics Forum | Thu Apr 15 20:41:22 EDT 2004 | Ken
There are ledgitimate reasons for checking furnace calibrations, but let me clarify what that is. 1. TC's are not necessarily calibrted. Not unless you need "absolute" accuracy. TC's operate against a (non-linear) standard +/- a tolerance. Most
Electronics Forum | Mon Apr 09 14:05:25 EDT 2001 | slthomas
CAL's word of caution is right on. We tend to stay in the 220C-225C max. temp. on our profiles, and that's because the last heads up from engineering came on a part with a spec. of 230C max. temp. We just found out that one of our old SOIC's is spe
Electronics Forum | Sun Jul 29 21:33:30 EDT 2001 | CAL
Your Ionograph and Zero-ion Values are set by you. There is no raw pass of fail criteria only the limits you set up. Ionograph is great for bare board resistivity (salt) test just as a pass fail for incoming inspection but this is all per your facto
Electronics Forum | Tue Jul 30 02:14:09 EDT 2002 | - One of the 2 percenters -
Buy American is the answer, however we must also change business ethics. US business has devalued quality and bolstered their legal departments!!! It is easier to make legal statements defending your product when it fails, rather then pay educated,
Electronics Forum | Tue Jul 29 09:47:40 EDT 2003 | davef
We agree with Russ and Ioan that rework does not cause black pad. It's caused during the board fabrication process. On the other hand, we think: * Mantis wants to reduce the amount of reworking of boards that fail due to a black pad problem. *
Electronics Forum | Thu Aug 26 13:51:57 EDT 2004 | Dreamsniper
I've done a few capacity and capability studies and bought new SMT equipment (Pick and Place) based on the above required capacity. I did not rely on equipment manufacturer's tact time. I used only 60% of their tact time as achievable in real manufac