Electronics Forum | Tue Mar 20 05:03:47 EDT 2012 | sunyb123
Dear sir, i have face same problem of motor Communication fail Card0,Card1,I Clean Whole card properly, change the battery new one ,reprogrammed mint, but Card 2&Card3 loaded the mint programmed but not in card 0 & card 1, Please suggest what to d
Electronics Forum | Thu Jul 20 11:18:43 EDT 2006 | ev
Paul, the error says "MOT1-38-247 MSETDYNX: Xwagon fan not working." I have checked...the X motor fan and it is working...the fan behind the PAIB board is also working...I checked this because there is a connector marked X wagon fan on the PAIB boa
Electronics Forum | Sun Sep 25 16:40:09 EDT 2011 | cbroegger
Have been through the same problem with the eurostep cards. The missing communications with the cards, suggest that some acid leaked from the batteries have etched tracks/and or the serial converters (soic8) on the cards. In all cases, clean the card
Electronics Forum | Wed Jul 26 16:08:29 EDT 2006 | ev
My focus has moved to the X motor itself. The one common factor in this paricular problem has been the time of year. The day was a particularly hot day with high humidity. Even though there is a "Xfan" connection on the PIAB board I do not believe th
Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Electronics Forum | Sat Jul 05 14:07:33 EDT 2008 | shellydhami
Main diffrences in failure modes for mechanically and thermally induced BGA solder joint fracture
Electronics Forum | Tue Nov 10 19:46:13 EST 2020 | dekhead
Still t issue if yu remove FDD from boot sequence?
Electronics Forum | Mon Jul 30 20:38:02 EDT 2012 | davef
I'm with you on microcracking. The best way to confirm this is through sectioning of the affected capacitors. You're fortunate to be seeing these failures showing-up early in your product life. Of times these failures don't appear for years.
Electronics Forum | Tue Nov 10 19:31:09 EST 2020 | mikewschomisch
I have been able to manually enter CMOS info in SETUP thanks to suggestions from this forum and get past the CMOS and EEPROM failures. Now stuck "diskette error". Any key will produce the same message. Thanks.
Electronics Forum | Tue Nov 10 21:00:41 EST 2020 | mikewschomisch
I removed the ribbon cable from the FDD and edited the setting in SETUP to "NOT Installed";. Came back with 'Diskette drive failure on drive A'. on reboot. Still shows "Diskette error" on last line. Possible HDD issue? Thanks.