Electronics Forum | Fri Jul 21 09:41:32 EDT 2006 | cyber_wolf
If its just the X axis then I would say that there is most likely something wrong with the ball screw. Does it only do it when the axis is moving fast ? Take the support plates out and check for anything out of the ordinary under there.
Electronics Forum | Mon Jan 22 12:08:42 EST 2007 | Grant
Hi, Perhaps you could call the guys at Soltec in Singapore, as we have dealt with them in the past, and they were very fast to help. Regards, Grant
Electronics Forum | Tue Feb 06 10:43:18 EST 2007 | James
Especially on capacitors, the tape is so thick that the motor starts to slow down and does not advance the parts fast enough or not at all. This happens on regular 8mm.
Electronics Forum | Wed Mar 07 04:01:23 EST 2007 | AR
Hi all Everybody seems to be touting the fast changeover capabilities of the Mydata machines. What is it exactly that makes Mydatas so great in this (very important) area, above other brands? I am not attempting to play down the Mydata, I am just ge
Electronics Forum | Fri Mar 09 08:09:56 EST 2007 | gregp
hello again Grant, the inquiry was about fast changeover--some people (you, for instance) may not be aware of some machines capabilities or changeover concepts even with your vast experience with Mydata and Fuji.
Electronics Forum | Tue Mar 13 11:45:56 EDT 2007 | realchunks
Hi Sr. http://www.oee.com/pdf/fast-guide-to-oee.pdf Pages 10 and 11 (I believe) will get you going.
Electronics Forum | Thu Apr 05 12:02:28 EDT 2007 | Rob
Hi John, Depending on what cameras it has it will do most of what you want, however it won't do it very fast. Also the operating system may make you cry. Regarding accuracy, repeatability, oddform etc it is very good. Good luck, Rob.
Electronics Forum | Wed Mar 28 09:22:50 EDT 2007 | Rob
Not a fan of bench top, as you have to load the component and the board into a fixture, then unload afterwards. We trialled with 3 linked ones for some complex boards which worked well, however it was not cheap, and not that fast. I'd look at sel
Electronics Forum | Tue May 22 09:37:11 EDT 2007 | jdengler
Hi Joakim, I do not know the QP242 table, but on our GP-341, CP-IV-2 and IP-III we make a plate from plexiglass with milled holes to show where the supports go for each board. This is not as fast as the Gridlock but does not cost nearly as much. J
Electronics Forum | Mon Jun 25 18:15:14 EDT 2007 | ratsalad
Your placement machines are too fast. Slow them down and the line will be balanced. This is the easiest way to make the industrial engineers happy.
