Electronics Forum | Mon Jun 08 16:57:09 EDT 2020 | joost
yes! this is what i was looking for, i figured it out today with the help of Michal who gave my 2 manuals. thank you very much for you're respond's. for the order that i just ran it gave me over 10% faster runspeed
Electronics Forum | Wed Aug 05 06:34:33 EDT 2020 | oxygensmd
Yes if you adjust the thickness to be thin than the machine raise the PCB more to the stencil - than the foil have better tension but it string out faster.
Electronics Forum | Fri May 14 20:21:11 EDT 2021 | bandjwet
Thanks for the reply. We are ramping up using soldering techs and convective hand soldering. We have investigated w/many soldering robot vendors. The number of units is over 100K. We will be automating using a dispense+pick and place for greater c
Electronics Forum | Sat May 15 20:32:55 EDT 2021 | dunks
Could you setup bga rework style machines with custom nozzles? Assuming your manual convection process consists of technicians with hot air pencils, and depending on part locations, this could potentially replace the manual part of that process.
Electronics Forum | Mon May 24 23:38:17 EDT 2021 | SMTA-64387687
What about dispensing SMT epoxy (cures at much lower temperatures, than solder reflow), p+p components, run through the oven to cure, and using a laser selective solder robot to solder the pads?
Electronics Forum | Sat Jun 05 13:55:14 EDT 2021 | ppcbs
With a reflow oven or BGA Rework Station I doubt you will get better than 2.5 minutes. Using a hot air pencil with about a 1/4" nozzle you can probably get 30 to 60 seconds depending on the density of your PCB?
Electronics Forum | Mon Jun 07 17:35:28 EDT 2021 | glasscake
100k units a year/month? that's quite alot. What exactly are you making? PCBS or something else? Is there a reason a traditional reflow oven will not work for you?
Electronics Forum | Sun Feb 20 10:54:14 EST 2022 | compit
Opal XII, MG-1 (and substitites from Yamaha available in Asia). Unlimited spare parts, cheap feeders, etc. MG-1 is faster, better for service (opinion of a friendly serviceman)
Electronics Forum | Mon Dec 19 15:53:21 EST 2022 | kumarb
Thank you Chris. Did not know that till now. Found the default above password faster on this forum than factory support. Very much appreciated. Thanks again.
Electronics Forum | Thu Jun 14 11:43:52 EDT 2001 | gsmguru
Change times for the Rheo pump are probably a little slower than just swapping blades. You have to hook up the sensors & air lines,remove the bottom cover + charge the pump to get it to operating pressure before you can print. I would guess that if y
