Electronics Forum | Fri May 29 02:08:08 EDT 2009 | cobar
Check that you are getting an even spray pattern from the fluxer.Check that the chip wave nozzle is clean and if possible feed the PCB in to the wavesolder unit at 90 � or 180�.
Electronics Forum | Thu Jul 09 13:19:38 EDT 2009 | emanuel
Just in case somebody will bump in the same situation and looks for a possible solution, the problem was with a small 2 pin connector that feeds one of the W DC motors. The connector looked ok, but one of the pins pulled a little out and was making
Electronics Forum | Sun Jul 26 17:13:31 EDT 2009 | slthomas
Is it possible that the assembler is using solder wire that's too small for the application and feeding it too quickly to compensate?
Electronics Forum | Fri Jun 04 14:08:59 EDT 2010 | deltaservices
I guess you mean the stick feeder. Most operators, just hold the new stick behind the one that is on the feeder and let the components slide over into the old stick. However, stick feeders are the worst way of feeding components.
Electronics Forum | Fri Jan 29 02:59:02 EST 2010 | szsummersun
hi peter, i have experience with manual soldering iron using automated wire feed,please email to me about it in detail,thank you.email:steven@ludeecircuits.com
Electronics Forum | Wed Jan 19 12:38:42 EST 2011 | atiya124
Does anyone know the quality and reliability of Icon I8 printer? We are looking to buy this printer and need feed back. Really appreciate for that.
Electronics Forum | Wed Sep 12 11:52:31 EDT 2012 | mtech88
Ben: you are right, I think the timing must be off some how. I will check the error code and post it back here. thanks David
Electronics Forum | Wed Sep 12 11:55:18 EDT 2012 | mtech88
Sr. Tech: I will check the air cylinder at the rear and see what position when the machine stop. Thanks David
Electronics Forum | Wed Mar 13 17:13:36 EDT 2013 | isd_jwendell
On an Essemtec machine I solved my sticky tape problem by routing the cover tape different than normal so that it pulls back more instead of up. I'm not familiar with your feeders and don't know if that is even a possibility.
Electronics Forum | Fri Apr 05 11:36:48 EDT 2013 | denisp
we use panasonic mv2vb feeder q type and we place a little piece of magnet under the reel and it help a lot
