Electronics Forum | Fri May 10 17:45:08 EDT 2002 | davef
Kinda makes ya wonder why ya changed, eh? Some of our 20 pitch HASL boards come-out just as flat as a farm pond. Just got ta letum be. Pete is spot on!!
Electronics Forum | Mon May 20 13:48:43 EDT 2002 | sbuckley
What is the recommended prep for a through-hole glass pack diode? Should a stand-off be used or can it lay flat on surface of the pcb?
Electronics Forum | Tue Jun 04 15:21:20 EDT 2002 | jax
To make it simple: A Feeder protection plate is just a flat piece of metal that hangs over the feeders, inside the machine, and keeps the feeder cover from popping up and crashing the head.
Electronics Forum | Thu Sep 26 12:21:24 EDT 2002 | dragonslayr
What are the specs of a Formica type bench top? Gloss or mottled finish? Should the edge be straight, rolled or bull-nosed? Can I get it in ESD safe composition? Can you recommend a good calibrator of formica?
Electronics Forum | Thu Sep 26 20:26:35 EDT 2002 | davef
I got one, but you don't need one. Coy, eh? Oh, but these measurements need to be soooo precise, don't they?
Electronics Forum | Mon Oct 14 14:46:10 EDT 2002 | sueph
Does anyone have a calibaration pocedure for flat radiant panel preheaters used in wave solder. Any info would be greatly appreciated.
Electronics Forum | Wed Jun 18 21:28:08 EDT 2003 | Larry D
Tom: Cheapest is grind flat spot on inspection mirror. Plastic mirror is easiest and works for the 1st 2 rows.
Electronics Forum | Sun Aug 31 23:53:40 EDT 2003 | Andy
Does any one know where I can obtain firmare for an HTI-7 screen printer. The internal memory battery went flat. I replaced the battery but the firmware was lost.
Electronics Forum | Tue Sep 16 13:44:38 EDT 2003 | Duane
Below 40 microinches = Bad Solderability With pitches getting smaller and smaller flatness becomes more of an issue, but it's not to be achieved by blowing ALL solder off the pads.
Electronics Forum | Mon Mar 01 01:03:27 EST 2004 | moncav
Hi, This is true if you are using the Grid-lok in the "full auto mode" which sets and resets for every pcb. Ohterwise you can teach the system a flat board (by various techniques) and it will maintain that profile throughout the product run. You sho