Electronics Forum | Tue Jul 19 18:08:28 EDT 2016 | dman97
Hello, I am having trouble getting our old CP3 to start up. When the machine starts to run, or when we try to center the nozzles, the CAM moves to 300 degrees and stops. The station 5 rotor just turns and turns with out ever centering the nozzles.
Electronics Forum | Wed Jul 19 12:25:47 EDT 2006 | Rob.
Hi Fabione, I'm not being funny, but how did you come up with that choice of machines? There is no way that these set ups are equal in speed or accuracy in the real world. I think you should go back to the drawing board & start again, and depending
Electronics Forum | Thu Sep 09 04:22:39 EDT 1999 | JAX
| | | | | I agree SB..Fuji feeders rarely get off that much.Are you using | | the Auto-Offset function in your Part data?This will | | usually keep your pick on Cp's humming! | | | | YES, always use the auto-offset function in each part data (do y
Electronics Forum | Fri Aug 14 15:47:31 EDT 1998 | Ben Salisbury
All we've bought is used equipment...and since the start I've learned alot about the inner workings of FUJI equipment. The first set of machines were bought from a re-seller, they were all functional but far from being in good shape. At the time, t
Electronics Forum | Thu Jun 28 11:51:24 EDT 2007 | mika
Hi, Are we talking about the pick-up tolerance so for any chip component set it to 0.5mm. It will save a lot of trouble right there. As for body tolerence if it is a zero then it will automatically use a standard value, based on the size of the body
Electronics Forum | Fri Jun 14 13:19:15 EDT 2002 | mjabure
The first question is, is this a high mix, low volume environment or vice versa? If it's the former then Kens solution is something you might want to look into. Depending on your feeder set up you might check to see if your operators have been traine
Electronics Forum | Wed Oct 15 15:08:05 EDT 2008 | mbrunton
I have a Fuji IP1 using the MCS control system. Everything works fine, but it seems to have tons of problems placing PLCC4 parts (Osram Power TopLED). Some reels I load up it will give a vision processing error for about 1 out of 10 parts. Other r
Electronics Forum | Thu Nov 11 09:49:20 EST 2004 | cyber_wolf
In the last 6 months or so we all of a sudden started having a placing problem on PLCC28 components. We are stumped, and Fuji is stumped. Has anyone ever seen this before ? (This is on a CP43) Here is what we have tried and verified: �� Nozzle def
Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl
I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -
Electronics Forum | Mon Jan 22 13:02:10 EST 2007 | shap
We are looking at replacing our aging 4790 for something. We are replacing our GSM1 with an Advantis. We are a prototype shop and do runs of 5 to 30 normally and once in a while a run of 300. So we are looking for flexibility and ease of set up.