Electronics Forum | Mon Jan 09 18:51:05 EST 2006 | grantp
Hi, I have used both MYDATA TP9, MY9 and more recently MY12. MYDATA machines are just not accurate, and we did everything possible, and every kind of upgrade they had. We ended up putting in Fuji XP based machines, and the differences are very notic
Electronics Forum | Sat Jan 08 00:47:12 EST 2005 | Grant
Hi, Yes, one of the problems with the MYDATA is the feeders are in groups, but at the same time, they are simple, and don't break. But the new Agillis 12 and 16 mm feeders do jam a bit. It's worse on glued cover tape, while heat bonded cover tape is
Electronics Forum | Fri Feb 11 00:51:22 EST 2005 | darby
We took our top 25 usage components on our top 10 production models and changed to 13"reels (8mm tape only). When we had 20 parts per we put 2x13" reels on when we had 30 parts per we put 3x13". On those particular products we went from changing up t
Electronics Forum | Thu Mar 24 17:36:31 EST 2005 | Grant
Hi, Yes MYDATA vibration feeders are a nightmare, but you might want to check the feeder. We had one that would vary a lot, and it never seemed to be able to be set to the right vibration level for consistent feeding. It turned out to have a problem
Electronics Forum | Tue Oct 18 17:06:04 EDT 2005 | stepheniii
At one time I could show you the spacing of the chain of an electrovert but the burn marks have dissapeared. The center support chain would wrap around and jam up and with boards in the oven.............. On that one for some reason we bought it wit
Electronics Forum | Wed Aug 02 15:19:29 EDT 2006 | SWAG
Sounds like air pressure is set O.K. The next thing to check is that the platen surface that the x and y axis ride on is perfectly clean. After that, you should knock the camera off the platen and make sure that all of the small air nozzles are blo
Electronics Forum | Wed Mar 21 17:47:05 EDT 2007 | darby
You need to use the H nozzle and 4 small jaws (1005). Have the slot in the jaws machined towards the rear of the jaw to increase reach. Set up and calibrate that head with that chucking assembly. Always use the same chucking assembly on the same he
Electronics Forum | Fri Nov 30 18:27:32 EST 2007 | jmelson
This doesn't help the original poster any, but does the Quad have any sensing of what is going on in the feeder? On the pneumatic or mechanical Philips feeders, if the tape jams in the feeder for some reason, the head just keeps tapping the lever an
Electronics Forum | Mon Jul 14 12:11:17 EDT 2014 | rgduval
We used to use the Tapesplicer tool available from http://www.tapesplice.com (Sierra Electronics), in a high mix, low volume environment with MyData's (older feeders). Short review: It worked. Longer review: First, technique is everything. Splicin
Electronics Forum | Mon Aug 10 15:34:00 EDT 2015 | rgduval
This issue has been haunting me for a little bit, but, it is now starting to really affect running boards. I'll be in the middle of a run, and have a feeder issue, and the GSM will identify the feeder. I'll review the issue (jammed tape, no part av