Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Mon Sep 26 18:46:37 EDT 2005 | stano
Hello. We have problem with MPA-V. Problem is with V1, V2 axis. Error is V1 AXIS MOVEMENT IMPOSSIBLE and V2 AXIS MOVEMENT IMPOSSIBLE. On the driver for this axis lighting error LED ST (sensor touble). It is problem in connection between motor encoder
Electronics Forum | Tue Apr 04 23:01:37 EDT 2000 | Dean
Does Fuji America have a trade in program? I know they used to on vision cards and such. It may be worth your while to get a trade in allowance rather than none at all. The alternative, as you mentioned, is to repair it yourself. This however, w
Electronics Forum | Fri Apr 12 16:13:36 EDT 2002 | pjc
Dave, USI makes spray fluxers with stepper motor and servo motor controlled traverse heads that only spray on the board. Virtually no waste going up the stack. www.ultraspray.com
Electronics Forum | Wed Dec 03 23:59:31 EST 2003 | masr
Basically the problem detail is, can't read the encoder reader from the motor, I swap the servo pack, the controler cards from the pc, the output cards from the plc, the motor and still have the problem!
Electronics Forum | Wed Jul 06 09:10:55 EDT 2011 | bobpan
i have seen bad motor cables cause the problem......you can ohm them out to the driver cards or if you have extras....replace them Bob
Electronics Forum | Wed Jun 08 14:04:50 EDT 2005 | cyber_wolf
If you are facing the back of the machine take left most panel off. There are usually two fans built into this panel.(unplug the fan connector and set cover aside) The servo-driver cards will all be in a row. They should be labeled accordingly.
Electronics Forum | Mon Oct 15 12:13:00 EDT 2012 | lkavan
Hallo friends, I am looking for interface board for Tenryu MT5530. Its name is DIF3-1. If you want, I can offer servo drivers or some pneumatic feeders for change. Thank you for help.
Electronics Forum | Wed Nov 02 21:34:38 EDT 2016 | ttheis
Check fuses, breakers and power supplies on the machine for proper operation. Start with the basics.
WINTECH provides new/used/pre-owned SMT, AI & PCB Assembly (PCBA) equipment of various brands. Also supply service, modification & original or local-made spare parts. We are also an appointed agent for well-known brands.
Equipment Dealer / Broker / Auctions
NO. 1 LORONG SAGA JAYA 6
PERAI, Malaysia
Phone: 6043809899