Electronics Forum | Thu Jan 06 07:55:22 EST 2000 | Roni Haviv
I need to Mfg. a PCB with 28"(660mm) length. Anyone knows who can do it (European Mfg. prefered) Thanks - Roni
Electronics Forum | Thu Dec 30 09:56:04 EST 1999 | Judy Forbes
Preleg wire is an epoxy coated wire. Is there an IPC standard or general rule for how Preleg wire (30 Awg) should be tacked down? Should it be tacked down every 1" as is regular wire - Or should it be tacked the whole length of the wire?
Electronics Forum | Wed Feb 24 07:56:53 EST 1999 | Brian C
Under IPC-A-610 Section 10.3(Components on their sides) it reads: ______________________________________________________ Acceptable - Class 1,2 Nonconforming Defect � Class 3 Chip components on its side provided the following are met: Chip
Electronics Forum | Wed Feb 24 10:56:12 EST 1999 | Steve Schrader
| Under IPC-A-610 Section 10.3(Components on their sides) it reads: | ______________________________________________________ | Acceptable - Class 1,2 | Nonconforming Defect � Class 3 | | Chip components on its side provided the following | are
Electronics Forum | Fri Oct 30 18:47:19 EST 1998 | phillip hunter
| Does anybody know how to update a different nozzle than the standard one on a Fuji IP3 machine? | | I want to use a 15.8 mm height nozzle, but the limit on height size is 10 mm for IP3.I know, I need to use a special nozzle, so I�m trying with a 1
Electronics Forum | Wed Mar 11 15:39:34 EST 1998 | ETS
For Sale: Full convection reflow oven, slightly used. 5 zone, 100" heated length, 200" overall. 40" cooling zone, edge rail conveyor, built in profiler. For information contact Brian Stumm @ 509-483-0900 or by e-mail.
Electronics Forum | Wed May 01 09:38:04 EDT 2002 | Col
Having been a user of the agillis feeder they are excellent and perform as the should do 1 slight complaint would be the length of coverlay needs to be long if its too short it can cause issues with fouling in the machine.
Electronics Forum | Thu May 30 08:04:25 EDT 2002 | zanolli
Hello Russ, I'm not quite sure I understand your question. Are you saying that you must hand solder these connectors because the gold plating doesn't allow other though hole processing methods to wet the solder the length of the pin in the PTH? Reg
Electronics Forum | Fri May 31 09:13:12 EDT 2002 | russ
Jim, you are right in this. these connectors have long pins 1/2" or so that protrude through the board and are used for mating into a female connector on some other assembly. due to both length and "no solder allowed in contact area" criterias thes
Electronics Forum | Thu Jul 11 06:56:30 EDT 2002 | davef
We have had failure due to a leakage in one ceramic chip capacitor. External inspection did not show any obvious damage. Cross section showed a void in the capacitor. The void was an elliptical shape and positioned longitudinal to the length of the c
