Electronics Forum | Mon Jul 20 15:53:10 EDT 2020 | robl
Tape test to check adhesion and multiple point thickness test - each board has 5 points per side documented for thickness testing & we measure pre & post coating thickness with an electronic meter. Also temp & humidty are also logged, and alarms go o
Electronics Forum | Tue Dec 21 17:15:49 EST 2021 | vtdivtecs
yeap I was able to figure it out and avoid my head being on a stick anywhere. if you log out of tpsys and into hw config you can turn off the hydra head there, then unplug the hardware and the machine will run. if you just disable it inside tpsys t
Electronics Forum | Wed Feb 02 08:11:03 EST 2022 | openindus
Thanks for the answer. Our camera doesn't even move during USC Park initialization. I assume it's a condition which isn't met to launch the sequence, but all the sensors seems to be fine. Could you send me the log (SECSDBUG.TXT) of your machine dur
Electronics Forum | Thu Mar 30 20:39:17 EDT 2023 | poly
Problem solved. I just check the modification time of the log, read from where I last read up to, then close it, send result over mqtt to inventree. Little fiddly to get some modern stuff running on win 2k but wasn't too bad.
Electronics Forum | Wed Nov 16 03:41:43 EST 2016 | Haizen
I need to extract data from a log file and sort the data in an Excel file. Details are as follows: - Log File is a measurement result produced by an In-Circuit Tester (no info. about it, no name, no type, nothing). - Measurement Result is from
Electronics Forum | Tue Feb 15 18:03:56 EST 2000 | JAX
Dane, I'll give you a quick guess before I log off; The reason you are seeing problems with dome shaped fiducials is probably because the machines in question do not use grey scale recognition. They asign either black or white( not 256 shades of grey
Electronics Forum | Tue Jul 11 11:59:34 EDT 2000 | George English
Looking for some welcome advise again folks. We are currently using a reflow profiling software package which requires passing a data logging unit through the oven attached via thermocouples to a populated 'dummy' PCB. The problem is we have a very
Electronics Forum | Mon Jun 12 10:11:43 EDT 2000 | Neil Peaslee
Steve, Thanks for notifying us of the broken link. Unfortunately, the destination that the link points to is not on the SMTnet site. The paper that you are searching for resides on the ITM, Inc. site and their site appears to be down at this time. If
Electronics Forum | Mon Jun 12 10:11:45 EDT 2000 | Neil Peaslee
Steve, Thanks for notifying us of the broken link. Unfortunately, the destination that the link points to is not on the SMTnet site. The paper that you are searching for resides on the ITM, Inc. site and their site appears to be down at this time. If
Electronics Forum | Fri Apr 14 09:14:29 EDT 2000 | Rich Ziebell
C.Long, Have you thought of using a barcode reader system? Though costly, such a sytem would minimize the room for error and neglect by your operators. Yes, physical tickets would still need to be applied (barcodes labels) but there would be less ef
