Electronics Forum | Wed Aug 11 09:51:11 EDT 1999 | Brian
| | | Easy goods-in polymerisation check: clean, white, cotton cloth: wrap it round a suitably gloved finger and pour a few drops of methylene chloride (! toxic) onto the end of the finger and rub it onto the bare board for a minute or so. If it come
Electronics Forum | Thu Aug 12 05:33:23 EDT 1999 | Brian
| | (snip) | | | | You're quite right. However, anyone who uses MeCl in an aerosol spray needs his head examining. I'll go further: if he continues, he will most CERTAINLY need his head, the rest of his CNS and his liver examining a little later on
Electronics Forum | Thu Aug 12 22:23:23 EDT 1999 | Dave F
| | | | (snip) | | | | | | You're quite right. However, anyone who uses MeCl in an aerosol spray needs his head examining. I'll go further: if he continues, he will most CERTAINLY need his head, the rest of his CNS and his liver examining a little
Electronics Forum | Fri Aug 13 10:39:25 EDT 1999 | Boca
| | | | | | (snip) | | | | | | | | You're quite right. However, anyone who uses MeCl in an aerosol spray needs his head examining. I'll go further: if he continues, he will most CERTAINLY need his head, the rest of his CNS and his liver examining a
Electronics Forum | Sun Aug 15 05:45:15 EDT 1999 | Brian
Boca, Dave Sorry, but I cannot let this go. I'll go along with you that, at the time that the Montreal Protocol was initially signed (September 1987), there was no scientific proof that CFCs etc. were causing ozone depletion. There was, however, ve
Electronics Forum | Fri Jan 29 16:17:13 EST 2021 | donnie15
The impact is low on larger pitches and pad sizes. as things get to the .4mm pitch the pad differences start affect your ball size and yields. The trace size going into the pads and the solder mask relief can cause some odd shaped pads with signif
Electronics Forum | Fri Jan 22 16:03:17 EST 2021 | SMTA-64387124
Does anyone see any issues in mixing SMD and NSMD pads within one BGA footprint. We have high current pads which we want to make SMD and the other signal pads to be NSMD
Electronics Forum | Tue Feb 09 16:53:06 EST 2021 | SMTA-64387083
The size of the pad changes among the two. A solder mask defined pad will always be larger than a copper defined by your mask expansion setting. This will affect paste volume, if your standard paste aperture is designed for copper defined pads you m
Electronics Forum | Sat Aug 14 17:39:37 EDT 1999 | Gerry S.
One of the DFM suggestions I've seen is to remove the solder mask web, i.e. the mask between pads on 20-mil QFP devices. The rational is that if the mask is thicker than the pad the mask can prevent the stencil from making intimate contact with the
Electronics Forum | Mon Aug 21 09:11:30 EDT 2000 | Eric Soderberg
Currently use Hysol TS300 latex mask and need to explore alternative methods of drying the mask. The mask is applied with a Asymtek Century Dispenser and placed on drying shelves. Air dry is dependent on temperature/humidity. Tried all the UV masks o
.gif)
