Electronics Forum | Wed Jul 15 12:44:11 EDT 2009 | thanhnguyen
The Tant size is 3528-21. I use type 72 nozzle > for it. check your vacuum valve, manually turn it on and off,i have the same problem like that b-4, after replacing the vacuum valve, the problem went away.
Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
Electronics Forum | Sun Dec 19 08:05:14 EST 1999 | Dave F
Clarissa: We've all done thing on a limited basis, especially on prototype boards, but this doesn't sound like a limited basis, or prototype boards. (And may be I reading too much into this, we all know the frailities of conversing like this.) Thi
Electronics Forum | Fri May 01 22:22:20 EDT 2009 | rodrigo
We didn't leave them swapted. They were placed in the original position until we got the replacement. What has me puzzled is that it worked for one panel correctly. I want to answer the other posts here too ... SA-6 is for Z2 The amp showing 7 is f
Electronics Forum | Mon Jul 13 13:48:37 EDT 2009 | christian01976
Hello! You can check your vacuum in MANUAL and then VACUUM IN MONITOR. You can switch the vacuum on or off for each head. With a TYPE 72 nozzle and no component the vacuum should be around 80 or 90 and with a component at the nozzle it should be ove
Electronics Forum | Fri May 01 16:04:17 EDT 2009 | jimmyboz
I found your ealier thread, when you swapped amps for trouble-shooting, as a rule of thumb, always swap them back, otherwise, you may introduce a new unexperienced problem. The original problem, (Z2 according to the thread) will not influence H1 unl
Electronics Forum | Mon Jul 13 11:34:44 EDT 2009 | snsmt
thanks everyone! When we have a PCB to do, for one component, they usually give us an excess of 10 components! We are issued over 2,000 components. Does that sound reasonable? The problem is usually when the head picks up the component before it r
Electronics Forum | Tue Jul 14 13:45:04 EDT 2009 | christian01976
Hello! You could check your pick an mount vacuum, too. You can do it in COMPONENT INFO with the ADJUST ASSISTANT (F6). Then PICK UP COMPONENT. If you don´t know how to read the grafic that is shown then just push F1 for HELP. What size do the TANT h
Electronics Forum | Mon Aug 27 15:54:30 EDT 2012 | markhoch
I have a couple of places you can check. Cardinal Circuit www.cardinalcircuit.com and Enterprise Engineering (They're in Hungary) Enterprise Engineering KFT. Tünde utca 18. H-4400 Nyiregyhaza/ Hungary Tel. +36/ 70 425 1433 E-mail: enterprise.
Electronics Forum | Thu May 18 10:48:09 EDT 2006 | vikkaraja
Hi There, I used to have a similar problem with all of our new heller ovens. I converted them with fan blower controller kit. It is really easy to do or you can have done. Its about $900/oven. For now if you do not feel like investing any money , go