Electronics Forum | Tue Aug 29 11:09:56 EDT 2023 | dimamalin
Our company has purchased five new MPM printers (2 BTB ,3 HiE) and a common issue for all the machines is the offset changes. Whenever we start working with an existing program, we always need to adjust the offsets. How can we avoid this?
Electronics Forum | Wed Aug 30 10:42:42 EDT 2006 | chrisgriffin
I would recommend the UP2000 HiE. This would more than handle what you have describe. If you have a lot of warped boards, the side clamp retro might be for you. I haven't had much production experience with the grid lock, but I know of several pe
Electronics Forum | Thu Jul 25 19:18:42 EDT 2002 | lysik
I really would not compare the 2 systems. A ELA is more like MPM's UP-1500. The UP-2000 is more like the DEK Horizon or Infinity. You just opened up one of the great debates of the SMT world. MPM or DEK? You will have people on both sides defend the
Electronics Forum | Wed Dec 13 16:40:40 EST 2000 | Bill Fluegel
I am receiving a "cognex not found" error upon bootup of a MPM AP24-X stencil printer. I have checked everything I can find between the cognex computer and the one in the machine. Has anyone experienced this before? Any ideas would be greatly appr
Electronics Forum | Fri Oct 29 15:29:56 EDT 2004 | jasont
Hi Ran, Have you considered 2nd hand screen printers? We are an SMT equipment re-seller but also operate a subsidary CM factory in SuZhou, China . We use Dek 265 LT and MPM AP screen printers in our SuZhou factory and have the following in stock f
Electronics Forum | Wed May 15 15:55:52 EDT 2002 | swagner
The Dek Infinity will cost you anywhere from $170-$210k dependant on option, I.E. gold camera, form flex support tooling, proflow printhead, paste inspection and aperature inspection all drive the cost of this machine. The only MPM I have quoted lat
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Mon Apr 28 21:51:56 EDT 2014 | elabcircuits
Hello, We have a MPM UP2000 HiE printer from 2000, software version 7.2E. The PC board is not booting anymore (black screen), no drives spinning. It's an Advantech 486SX version. Question: would a Pentium 3 SBC (Single Board Computer) with ISA
Electronics Forum | Wed Dec 28 18:09:47 EST 2022 | atpico
Second question concerning MPM UP2000HiE: Are there two options of conveyor lengths for this printer? Looking for conveyor belts spare parts I found two options: One 137" and one 106" that gives about 134 and 174cm total conveyor lengths. Does any
Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t