Electronics Forum | Fri Sep 01 15:28:42 EDT 2006 | Hussman
H ilarious. E ven tho I don't come here much, it's the same old thing. R eplayed questions, answered by self righteous people. B ut several people told me to check out this thread. P erhaps they are right. A lthough it�s the same old people banterin
Electronics Forum | Thu Sep 07 14:49:18 EDT 2006 | C.K.
Sr. Tech. It's a fancy way of saying that he'll look into how risky it is to buy a used piece of equipment from him. We have a new guy like that here at my place of employment. He wears a necktie (when it's not required) and then talks slowly and
Electronics Forum | Wed Aug 30 23:58:53 EDT 2006 | jasmin
We are looking into purchasing a used UP-2000 > Hi-e. We are high mix /high change-over. The > machines I am looking at are equipped with the > grid-lok system. > > Can anyone give me pros's/ > con's ?? > > Thanks in advance. > > Sr. Hi Sr T
Electronics Forum | Thu Sep 07 09:04:24 EDT 2006 | Doug Eidle
Hi, First off, I am the Pre Owned Equip. Business Mgr. for Speedline Technologies. We have a factory Renewed (our enhanced refurbishment process) available. You can contact your local Speedline MPM Rep for price and information. If board warp is
Electronics Forum | Thu Aug 31 19:40:22 EDT 2006 | cardinal
A couple things on the Grid-Lok system. They now offer a top-side edge clamping system. The edge clamping system works very well for warped, twisted boards etc.. Using this system in the auto mode also allows the pins to contour to the geography of
Electronics Forum | Thu Aug 31 18:58:37 EDT 2006 | chrisgriffin
Fastek, You are correct. I know of machines you can get for 25k that are in working condition. But if I was going to buy one used, I would want it refurbished and calibrated. I would also be interested in support and warranty. I don't know of an
Electronics Forum | Tue Aug 29 10:36:09 EDT 2006 | Chunks
With the UP2000 that has vacuum board hold down, the Grid Loc hoses defeat the vacuum in order for them to exit the work table. Big boards require more girds, thus more hoses. Set-up between large and small boards takes time to remove or add the gr
Electronics Forum | Thu Jul 25 20:47:13 EDT 2002 | Dreamsniper
Thanks for that info... I found out that MPM has UP2000 HiE VP with price lower than DEK Horizon but just a bit higher or let's say relatively the same as DEK ELA...I find it hard to decide which among the 2 based on our budget capability. My budget
Electronics Forum | Thu Aug 31 21:43:13 EDT 2006 | fastek
I don't sell them for $25K either but my point is they can be had for that price. In fact the last (2) that I had I purchased for $8K and $9K. I never have claimed to be the cheapest dealer around and it's not my intention......I only intend to be
Electronics Forum | Tue Sep 05 16:26:53 EDT 2006 | Bill
Thinking about this auto-mode on Grid-Lok..... Ok, the board is warped, lets say positively, the pins conform to the warped board... what about the effect on top side and squeegee pressure? It will be much higher and could damage stencils, right? Pos
.gif)
