Electronics Forum | Fri Sep 22 08:37:47 EDT 2006 | john
Using MPM UP2000 Hie printer.When give cycle wiper command,After comleting forward stroke machine gives error wiper not parked,press next to continue.If press NEXT VY axis software limit comes and machine give message press NEXT to continue.IF press
Electronics Forum | Thu Dec 29 18:44:36 EST 2022 | compit
Yes, there are two lengths. My MPM UltraPrint 2000 HiE has trays protruding from the machine about 15 cm, I think. I'll check with the company tomorrow to see if there are any numbers in the manual. I have a link to the part saved - maybe check it ou
Electronics Forum | Tue Nov 30 20:44:09 EST 2004 | bbyrd36
Good Evening - I am looking to purchase a video card for my UP 2000. The current configuration has a two board design and I am in need of the board mounted on the right looking from the back. Please contact me if you have one with availablity and p
Electronics Forum | Fri May 05 21:10:41 EDT 2023 | zsoden
Hi ELC, I'm curious about your comment of calibrating the Z axis. Our UP2000 has been moved around a few times and we've never done this nor noticed a need to. Could you please share some more information and even perhaps the calibration procedure?
Electronics Forum | Wed May 15 15:55:52 EDT 2002 | swagner
The Dek Infinity will cost you anywhere from $170-$210k dependant on option, I.E. gold camera, form flex support tooling, proflow printhead, paste inspection and aperature inspection all drive the cost of this machine. The only MPM I have quoted lat
Electronics Forum | Tue Aug 29 14:21:24 EDT 2006 | billyd
Dude: I have used the Grid-lok system before, in DEK 265 and DEK Infinity printers (clamps) and they worked quite well. But, we did have the side clamps. I'm not sure how that translates to an MPM. They were the best we could find as far as the
Electronics Forum | Thu Feb 15 12:34:11 EST 2007 | flipit
Does Ekra or MPM require stencil fiducials be filled with Black Max or some other black epoxy? We still require our stencil supplier to do this. I did not have to do this on any Dek solder printers since 1997. Can the MPM UP2000 HiE fiducial light
Electronics Forum | Fri May 04 14:47:15 EDT 2007 | jasont
Chris, I have x2 units available in my Brockville, Canada warehouse now. They are off MPM UP 2000 HiE's and the model #'s are as follows; MCU012A-SOO AP25-917A Please e-mail directly at jason@tekmart.com Looking forward to your reply, Jason
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t