Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Fri Nov 14 10:56:12 EST 2014 | max83
We are working with SMT lines consisting of > machines opalxii after 5/6 years of operation > have appeared problems in operation of the > engines on the x and y axes. I disassembled the > engines from the machine and I removed the cap > that c
Electronics Forum | Thu Jun 28 20:11:32 EDT 2007 | rfrog
Hi folks, I've been bouncing off of MyData technical support for some time on an issue with a MyData machine. Seems that this My9 likes to skip an 0402 placement at a rate of ~ 1000/million. Profile: MyData My9 Mechanical centering Midas only
Electronics Forum | Tue Jul 10 16:13:52 EDT 2007 | bk
Hi folks, I've been bouncing off of MyData > technical support for some time on an issue with > a MyData machine. Seems that this My9 likes to > skip an 0402 placement at a rate of ~ > 1000/million. > > Profile: MyData > My9 Mechanical ce
Electronics Forum | Wed Jun 24 08:19:59 EDT 2009 | fujiphil
Hi, Procedure how to replace the x-ballscrew of CP642. 1. Before you remove the x-motor, remember the pulse of x-axis motor just it turn ON the zero set sensor. Pulse usually at 1000pls. +/-50pls. 2. Turn Off the machine. 3. Compress the two ballsc
Electronics Forum | Tue Jan 11 09:58:18 EST 2005 | jdumont
Well we actually bought a used 3AV system. Been running with no problems at all for a while now. We also already had a 3Z system that has not fared so well. We have replaced both the Y motors, 3 of the 4 Z motors, belts, pulleys, PCB's, spindles...et
Electronics Forum | Mon Nov 10 04:05:56 EST 2014 | moshe_shmuel
We are working with SMT lines consisting of machines opalxii after 5/6 years of operation have appeared problems in operation of the engines on the x and y axes. I disassembled the engines from the machine and I removed the cap that covers the encod
Electronics Forum | Wed Mar 16 17:43:33 EST 2005 | pmd
We grease acording to PM schedule. The cable is very old about 5 years. We run 2 shifts. The transducer program and burnin test show the varance that we are seeing phisically so I can rule out the transducer. The motor may be the cause as it is of 19
Electronics Forum | Fri Aug 11 12:45:10 EDT 2006 | mpm fan
It's been awhile but isn't there a sensor to tell the middle conveyor when it is lined up with the incoming and outgoing rails? If so that would explain why the table goes into Z axis overtravel. It still means your Y isn't working but makes it less
Electronics Forum | Sat Sep 28 15:58:38 EDT 2013 | sonavc
Hi. 'm new to this Fuji CP3, I bought this machine in working condition ( I saw it ran, but I forgot to check the board in and out ).... Moved to my location, Problem: When the board is trying to load to the X-Y table, it passed the conveyor B but