Electronics Forum | Thu Jul 19 04:23:38 EDT 2007 | chrispy1963
You dont mention if it is ONLY occuring with the A12 or is it other tools as well? Only spring tools or Stiff ones? Regardless of that, the small X Wagon motor is controlled by the track ball and the bigger X Axis motor is controlled by the joystic
Electronics Forum | Fri Jul 20 07:09:29 EDT 2007 | chrispy1963
Sr. Tech, youre absolutely correct that the X-Wagon (pancake) motor is the one which will do final positioning when moving to a programmed position. The X Axis motor in back of the machine is used for rapid traverse of the axis. I was thinking more
Electronics Forum | Fri Sep 02 07:38:13 EDT 2005 | DannyJ
Hi Mike, I haven't tried the 0201s with a Hyrda, but after seeing 20 reviews of your message without a response, I'll try and share my experience with 0402s on a non-Hydra machine. The 0402s are slow, but I managed to get some speed by maxing out
Electronics Forum | Fri Oct 16 21:33:51 EDT 1998 | Scott
| I do not think that the Mydata can pick from wafer or has the accuracy required (12 micron)! Am I missing something? I don't have personnal experience with flip chip but the next time you're at Nepcon ask Mydata to show you their demo board with
Electronics Forum | Fri Jan 10 11:32:52 EST 2014 | rgduval
Hi, Hans, I would have suggested swapping the MOT card out to see if that fixes the issue (or, changing the MOT card with another one to isolate the card), but, it sounds like you've already done that. I'm surprised that MyData would point you towa
Electronics Forum | Wed Sep 08 15:59:25 EDT 2004 | kbayram
Hello, I'm looking for a lower end used machine that can place a 55x44mm sized bga component, placement speed is n't concern. At the moment I have only found the quad ivc to be capable although I'm worried about the placement accuracy and repeatabi
Electronics Forum | Thu Mar 22 09:49:16 EDT 2007 | Manyhatz
You shouldn't have any problem with the SM320 doing what you're asking above. In fact I think it will do it quite better. We have a two machine TP-11 Hydra line and a two machine SM320 line and I can tell you one SM320 can get the job done better.
Electronics Forum | Wed Jul 18 03:55:39 EDT 2007 | allgood
Thank you for the reply - and yes its a TP9-UFP! Problem doesnt happen all the time and may not happen for extended periods on the job where we see it most - this particular job uses all feeder slots so the head is whizzing back and forth quite a l
Electronics Forum | Tue Aug 18 10:17:15 EDT 2009 | grantp
Hi, You don't need X-ray and all that crap. I would get an old MYDATA TP9 or something like that, and a manual stencil printer and a batch oven or a small inline oven. Should do the trick and be very low cost. Should be simple to use as well. Tha
Electronics Forum | Fri Oct 16 00:23:16 EDT 1998 | Jim McCarten
I do not think that the Mydata can pick from wafer or has the accuracy required (12 micron)! Am I missing something? | | I need to install some new lines for high mix low volume products in an already cramp building. Could someone share any info a