Electronics Forum | Wed Jun 12 10:53:15 EDT 2002 | genny
350 candlepower is fairly low for high detail work. I spent some time in the construction industry laying out electrical blueprints for schools, and such. It was desirable to have more in the order of 700 fc for the desk surface that kids would wor
Electronics Forum | Thu Jul 11 21:41:57 EDT 2002 | lysik
No company can deny service to any company that has a machine. If they require a company to register a used machine to get support any company can register it. Weather they are a user or reseller. The big three have looked into this with much time ,
Electronics Forum | Mon Apr 25 11:24:31 EDT 2005 | Daan Terstegge
I have a question about inspection, touch-up, and how far you need to go to get a product that meets the required IPC-spec. According to some reports (i.e. "New Study Reveals Component Defect Levels" by Stig Oresjo of Agilent) the average defect leve
Electronics Forum | Tue Jun 19 13:57:40 EDT 2007 | realchunks
Hi Bill, You should contact your local water work dept. and work with them. Every county is different. Sometimes it not what you put in the drain, but how much. They may want to monitor your drain, which is standard stuff. Be prepared to show th
Electronics Forum | Wed Jan 30 03:20:00 EST 2019 | bane016
We measure each first board before the oven after every chageover...Assembling one offset and measure component, after we clear plate...We have reason why do that...But we're wasting a lot of time.So I wanted to see how you do it. Thank you for answe
Electronics Forum | Wed Aug 23 14:52:10 EDT 2000 | Steve Thomas
Every forum I've ever frequented has been plagued with repeat questions. It's not just technical forums, either. Until someone creates a forum that funnels first time users DIRECTLY into the FAQ (and not just the ones about how the forum works)an
Electronics Forum | Tue Aug 13 01:53:19 EDT 2002 | kenbliss
Hey Tony Although clearly everyone so far on this forum agrees that there is no real number in real life and virtual life is well....useless. The reality is that what you are really after is maximizing uptime, meaning, look closely at every event t
Electronics Forum | Thu Dec 05 11:36:30 EST 2002 | William Guatemala
Have you check the flux gravity lately? If not, Check the flux gravity every 6 hours to make sure proper parameters are meet. Here is a list of things that may cause your solder ball problems; Excecive heat, defective fixtures, preheating temperature
Electronics Forum | Sun Jul 18 14:01:25 EDT 2004 | KEN
Unfortunately, smt machines are not like TH sequencers. But, that is in their favor. Multiple reels, multiple part types, many positions = very flexible. Offline setup is paramount to line utilization. Remember, you only make money when the machi
Electronics Forum | Fri Apr 27 08:44:08 EDT 2007 | Brett
For those of you who use via holes as test points, and the via holes must be filled at the wave, is it necessary to have a "dome" on every single test point, or is it sufficient to have the via "filled" with solder? The ICT preson here insists that